TEC Air Flow Method Pressure Matching with Duct Blaster
INSTALLATION
- Operate the fan in the speed used for heat or cooling.
- Record the supply static pressure.
- Remove the filter and install duct blaster. Ensure there is no bypass around duct blaster.
- Turn on the system and (if necessary) the Duct Blaster to match previous measured supply static. Record the flow through a two-channel manometer once pressure is matched.
Documents / Resources
 |
TEC Air Flow Method Pressure Matching with Duct Blaster [pdf] Instruction Manual Air Flow Method Pressure Matching with Duct Blaster, Air Flow Method, Pressure Matching with Duct Blaster, Duct Blaster, Pressure Matching |
