TCP ISREMOTE Remote Control Instruction Manual

TCP ISREMOTE Remote Control

Product Specifications

• Brand: TCP
• Product: Remote Control
• Model: ISREMOTE
• Works with any IS Motion Sensor
• Customization of luminaires

The TCP IS Remote works with any IS Motion Sensor to allow easy customization of any of your luminaires.

Remote Usage Instructions

LED Brightness
Set the brightness level when occupancy is sensed and luminaire is switched on.

Sensitivity
Adjust the occupancy sensing sensitivity of the sensor.

Hold Time
Set the duration the sensor remains at full brightness before turning off or entering standby mode.

Daylight Sensor
Preset threshold levels for the daylight sensing functions.
*In applicable sensors only

Standby Dim
Adjust the lux value to act as the daylight threshold. This feature enables daylight sensor functionality in all applications. (Only applicable in certain sensors)

Standby Time
To set the bi-level dimming after the initial hold time. Setting standby dim level at 0% means the device will turn off after the initial hold time (Standard mode). Setting standby dim level to the other provided options will place the device in bi-level mode.

Set the current lux value as the daylight threshold. This feature enables the daylight sensor to function in all applications.
*In applicable sensors only

The daylight sensor is turned off and the sensor functions in standard or bi-level dimming mode.

Button Operation

• ON/OFF Button
  Press the ON/OFF button, the light goes to permanent on or permanent off mode, and the sensor is disabled (Must press the AUTO button to quit this mode for setting).
• 
  Display the current/latest setting parameters in LED indicators (the LED indicators will turn on for showing the setting parameters).
• RESET Button
  Press RESET button, all settings go back the settings of the dip switch in sensor.
• SELECT Button
  Select active parameter for editing after pressing DISP. The selected function will flash.
• OK Button
  Select OK to save the selected settings to the remote.
  Settings will be saved to the remote but will still need sent to the device
• SEND Button
  Press the SEND button to upload the current settings to the fixture (Press DISP to see current settings.) The fixture will flash on/off to confirm the settings have been received.
• 
  4 scene modes with preset parameters which are available to be changed and saved in modes.
• AUTO Button
  Press AUTO button, the sensor starts to function and all settings remain the same as the latest status before the light is switched on/off.
• TEST 2s Button
  The button TEST 2s is for testing purpose sensitivity only after you choose sensitivity thresholds, then you press the TEST 2s button.
  The sensor goes to test mode (hold time is only 2s) automatically, meanwhile the standby period and daylight sensor are disabled. Press AUTO button to quit from this mode.
• LEFT/RIGHT Buttons
  Navigate to LEFT and RIGHT to choose between options of the selected parameters in LED indicators
• UP/DOWN Buttons
  Open and close smart daylight sensor. Press UP or DOWN, enter in the setting condition, the parameter LEDs of remote control will flash to be selected, press this button to open or close smart daylight sensor.
  *In applicable sensors only

TECHNOLOGY CAST IN A BEAUTIFUL LIGHT

For over 30 years, TCP has been designing, developing and delivering energy-efficient lighting into the market. Thanks to our cutting-edge technology and manufacturing expertise, we have shipped billions of high quality lighting products. With TCP, you can count on a lighting product that is designed to meet the needs of the market – that transforms your surroundings and envelopes you in warmth – lighting that generates beauty with every flip of the switch.

For more information on the quality and care TCP can deliver, call us at 800.324.1496 or visit tcpi.com
325 Campus Dr. | Aurora, Ohio 44202 | P: 800.324.1496 | F: 877.487.0516

Frequently Asked Questions