TCP Smart Heating Automation Instructions
- From the homepage go to the SMART menu
- Start a smart automation using the + icon top righ
- Choose WHEN DEVICE STATUS CHANGES from the list
- Select your heater
- Choose CURRENT TEMPERATURE from the function menu
- Make sure the less than icon is selected and choose the desired minimum temperature
- Choose RUN THE DEVICE from the smart automation list
- Select your heater
- Select SWITCH from the function list to turn the heater on
- Make sure ON is selected
- Select MODE from the function list
- Choose the HIGH HEAT mode
- To set the target temperature choose TARGET TEMPERATURE from the function list
- Set the target temperature where the heater will turn off
- The Oscillation setting to rotate the heater can be chosen by selecting OSCILLATION from the functions list
- Choose whether you want the heater to oscillate from the menu
- Click NEXT
- The smart automation can be set to work at specific times. To do this select EFFECTIVE PERIOD
- Choose custom to set a the specific times
- Set the start and end time for the automation
- Slelect REPEAT from the list
- Select the days the automation should work
- The automation can be renamed if desired and save to finish
- You will now see the heater automation in the automation tab. Please ensure it is switched on
Documents / Resources
 |
TCP Smart Heating Automation [pdf] Instructions Heating Automation, Heating Automation with App |
