Tailcas B1vax-AXyDL LED Night Lights with Motion Sensor
CYCLE MODES
Warm Tips
- For the first use, please fully charge the night light.
- Don’t install the light next to the router.
- Do not install the light in a humid or high temperature place.
- The night light will only light up when motion is detected in the dark or in low light.
- Please do not install the 2 lights too close. If one light is on, the other light may not turn on.
Installation Steps
- STEP 1: Press the magnet piece behind the light lightly for more than 5s.
- STEP 2: Tear off the adhesive paper on the iron sheet.
- STEP 3: Press the iron sheet firmly on the wall.
- STEP 4: Attach the lamp to the iron sheet.
Service Email: Tailcas@outlook.com
Documents / Resources
 |
Tailcas B1vax-AXyDL LED Night Lights with Motion Sensor [pdf] Instruction Manual B1vax-AXyDL, B1vax-AXyDL LED Night Lights with Motion Sensor, LED Night Lights with Motion Sensor, Night Lights with Motion Sensor, Lights with Motion Sensor, Motion Sensor, Sensor |
