PV8-A Manuals / Datasheets / Instructions

RYDEEN PV8 HD Screen Digital Rearview Mirror Instruction Manual

Danfoss ICAD 600A-ICAD 1200A Motor Actuator without Cables Specifications Input Voltage: 24 Volt DC Max Torque: 3 Nm Operating Voltage Range: 21V DC - 26.4V DC Terminal Box Colors: A-Black, B-Brown, C-Red, D-Orange, E-Yellow, F-Green, G-Blue, I-Black Installation When installing the ICAD, ensure to cross-tighten all 3 screws to ensure equal tightening with a maximum torque of 3 Nm. Use a 24 Volt DC power source only. Terminal Box Setup Refer to the color codes provided for the terminal box connections. Make sure to observe the voltage drop in cables between the transformer and the ICAD terminal box to maintain voltage within the specified range. Programming the ICAD Power up the ICAD and wait for A1 to flash on the display. Hold down for 2 seconds to enter programming mode. Use the keypad to navigate through parameters and settings as required. To exit programming mode, hold down for 2 seconds. Factory Reset To perform a factory reset, disconnect power, press down and simultaneously while reconnect power, then release the buttons. The ICAD will indicate a reset by flashing A1 in the display. FAQ What should I do if the analogue input signal is out of range? If an A3 alarm occurs due to the analogue input signal being out of range, please refer to the ICAD instruction manual for troubleshooting steps. Installation Guide ICAD 600A/ICAD 1200A Quick Start Guide Note! Cross tighten all 3 screws to ensure equal tightening. Max 3 Nm torque. Ref. Colour Description A Black – Common Alarm B Brown – ICM fully open C Red – ICM fully closed D Orange – GND ground E Yellow + 0/4 – 20 mA Input F Green + 0/2 – 10 V input or digital input for on/off control G Blue + 0/4 – 20 mA Output I Black + Fail safe supply Battery / UPS* 19 V DC II White + Supply voltage 24 V DC III Brown – * Uninterruptable Power Supply Please observe cable voltage drop Distance between the applied DC transformer and the ICAD terminal box may cause a voltage drop. Cross section of cables and size of DC transformer must be calculated so that the voltage at all time at the ICAD terminal box*, both during standstill and during operation of ICAD, is within this range: 24 Volt DC ONLY * Do not measure inside the ICAD itself NOTE! If media temperature is lower than -30 °C (-22 °F) it is mandatory to set parameter i30 an i31. See separate document attached in ICAD box: document number AN285243155312 Changing analogue input signal (optional | AN213086423355en-000501

Discover the comprehensive user manual for the PV8 HD Screen Digital Rearview Mirror. Unveil details and instructions for PV8-A, RYDEEN, and other products. Access valuable insights in a convenient PDF format.

RYDEEN PV8-A Ultra Bright HD Rearview Mirror Owner’s Manual

RYDEEN-PV8-A-Ultra-Bright-HD-Rearview-Mirror-feature-image

Learn how to mount the PV8-A Ultra Bright HD Rearview Mirror with this user manual. Discover detailed instructions for mounting the D-TAB on the glass windshield.

Search for PV8-A Documents by Model Name or Number:

Tag Archives: PV8-A

RYDEEN PV8 HD Screen Digital Rearview Mirror Instruction Manual

RYDEEN PV8-A Ultra Bright HD Rearview Mirror Owner’s Manual