Engine Manuals & User Guides

TOYOTA EG2-326 Powertrain Control Module Engine Instruction Manual

April 16, 2026

EG2–326 5S–FE ENGINE – MPI SYSTEM POWERTRAIN CONTROL MODULE ENGINE (& ECT) (PCME (& T)) PCME (& T) FOR REMOVAL AND INSTALLATION PCME INSPECTION (See Components for Removal and Installation) HINT: The MPI circuit can be checked by measuring the…

Brand: Toyota

TOYOTA EG1-32 Engine Mechanical Instruction Manual

April 16, 2026

TOYOTA EG1-32 Engine Mechanical COMPRESSION CHECK HINT: If there is lack of power, excessive oil consumption or poor fuel economy, measure the com–pression pressure. WARM UP AND STOP ENGINE Allow the engine to warm up to normal operating temperature. DISCONNECT…

Brand: Toyota

TOYOTA 3S-GTE Engine Owner’s Manual

April 16, 2026

 3S-GTE Engine Owner's Manual GENERAL MAINTENANCE These are the maintenance and inspection items which are considered to be the owner’s responsibility. They can be performed by the owner or he can have them done at a service shop. These items…

Brand: Toyota

Toyota EG1-396 GTE Engine User Manual

April 16, 2026

EG1–396 3S–GTE ENGINE – SMPI SYSTEM AC IDLE–UP VALVE EG1-396 GTE Engine COMPONENTS FOR REMOVAL AND INSTALLATION A/C IDLE–UP VALVE INSPECTION (See Components for Removal and Installation) DISCONNECT CABLE FROM NEGATIVE TERMINAL OF BATTERY CAUTION: Turn the ignition switch to…

Brand: Toyota

TOYOTA EG2-26 Engine Mechanical Instruction Manual

April 16, 2026

TOYOTA EG2-26 Engine Mechanical COMPRESSION CHECK HINT: If there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. WARM UP AND STOP ENGINE Allow the engine to warm up to normal operating temperature. DISCONNECT…

Brand: Toyota

TOYOTA EG1-30 Engine Mechanical Instruction Manual

April 16, 2026

TOYOTA EG1-30 Engine Mechanical IDLE AND OR 2500 RPM CO HC CHECK HINT: This check is used only to determine whether or not the idle CO/HC complies with regulations. INITIAL CONDITIONS (a) Engine at normal operating temperature. (b) Air cleaner…

Brand: Toyota

TOYOTA EG2-24 Engine Mechanical Check Instruction

April 16, 2026

TOYOTA EG2-24 Engine Mechanical Check Specifications Test Modes: Idle and/or 2500 RPM CO/HC Check Engine Warm-up: Approximately 180 seconds at 2,500 RPM Probe Insertion Depth: At least 40 cm (1.3 ft) into tailpipe IDLE AND OR 2500 RPM CO HC…

Brand: Toyota

TOYOTA 2UZ-FE Engine Installation Guide

April 15, 2026

CH-13 CHARGING (2UZ-FE) - GENERATOR (Standard Spec.) CH0LP-01 REASSEMBLY 1. PLACE RECTIFIER END FRAME ON PULLEY 2. INSTALL ROTOR TO DRIVE END FRAME 3. INSTALL RECTIFIER END FRAME (a) Place the generator washer on the rotor. (b) Using a 29…

Brand: Toyota

TOYOTA DI-18 Corolla 1.8 Engine Instructions

April 14, 2026

DI−18 DIAGNOSTICS − ENGINE (1GR−FE) DIDSU−01 Instructions LIST OF DISABLED MONITORS HINT: This table indicates the ECM monitoring status for the items in the upper columns if the DTCs in each line on the left are being set. As for…

Brand: Toyota

Honda CG160 Engine User Manual

April 14, 2026

Honda CG160 Engine INTRODUCTION Thank you for purchasing a Honda engine. We want to help you to get the best results from your new engine and to operate it safely. This manual contains information on how to do that; please…

Brand: Honda