Configuration Manuals & User Guides

VANCO TP Link Switch Configuration Instructions

April 25, 2023

VANCO TP Link Switch Configuration TP Link Switch Configuration The EVO-IP HDMI over IP System is compatible with the following. TP Link Switches: TL-SG3428MP TL-SG3428XMP TL-SG3452P TL-SG3452XP Below are the configuration steps required to set up the system. The EVO-IP…

Brand: VANCO

Microsemi SmartFusion2 MSS GPIO Configuration User Manual

April 23, 2023

SmartFusion2 MSS GPIO Configuration User Manual Introduction The SmartFusion2 Microcontroller Subsystem (MSS) provides one GPIO hard peripheral (APB_1 sub bus) supporting 32 General Purpose I/Os. On the MSS canvas, you must enable (default) or disable the GPIO instance based on…

Brand: Microsemi

Microsemi SmartFusion2 MSS Peripheral DMA Configuration User Manual

April 23, 2023

SmartFusion2 MSS Peripheral DMA (PDMA) Configuration Configuration Options The Peripheral DMA (PDMA) engine offloads the ARM® Cortex™-M3 processor from data movement tasks. The PDMA allows data transfer from various MSS peripherals to memory, memory to various peripherals, and memory to…

Brand: Microsemi

Actel SmartDesign MSS SPI Configuration User Guide

April 21, 2023

SmartDesign MSS SPI Configuration User Guide Introduction The SmartFusion Microcontroller Subsystem (MSS) provides two SPI hard peripherals (APB_0 and APB_1 sub busses) with optional FPGA fabric slave select ports extension. The actual behavior of each SPI instance must be defined…

Brand: Actel

MICROCHIP Connectivity Fault Management Configuration User Guide

April 7, 2023

MICROCHIP Connectivity Fault Management Configuration Product Information The CFM Configuration Guide is a document that explains how to setup Connectivity Fault Management (CFM) features for networks. CFM is defined by the IEEE 802.1ag standard and provides protocols and practices for…

Brand: MICROCHIP

Microsemi IGLOO2 HPMS DDR Controller Configuration User Guide

March 30, 2023

Microsemi IGLOO2 HPMS DDR Controller Configuration Introduction The IGLOO2 HPMS has an embedded DDR controller (HPMS DDR). This DDR controller is intended to control an off-chip DDR memory. The HPMS DDR controller can be accessed from the HPMS (using HPDMA)…

Brand: Microsemi

Microsemi IGLOO2 HPMS DDR Bridge Configuration User Guide

March 29, 2023

Microsemi IGLOO2 HPMS DDR Bridge Configuration Configuration Options The HPMS DDR bridge is a data bridge between four AHB bus masters and a single AXI bus slave. It accumulates AHB writes into write combining buffers prior to bursting out to…

Brand: Microsemi

Microsemi SmartDesign MSS AHB Bus Matrix Configuration User Guide

March 27, 2023

SmartDesign MSS AHB Bus Matrix Configuration Libero® IDE Software Configuration Options The SmartFusion Microcontroller Subsystem AHB Bus Matrix is highly configurable. The MSS AHB Bus Matrix configurator enables you to define only a sub-set of the bus matrix configurations. The…

Brand: Microsemi

Actel SmartDesign MSS Timer Configuration User Guide

March 25, 2023

Actel SmartDesign MSS Timer Configuration Actel Corporation, Mountain View, CA 94043 © 2010 Actel Corporation. All rights reserved. Printed in the United States of America Part Number: 5-02-00245-0 Release: June 2010 No part of this document may be copied or…

Brand: Actel

Microsemi SmartDesign MSS GPIO Configuration User Manual

March 25, 2023

Microsemi SmartDesign MSS GPIO Configuration The SmartFusion Microcontroller Subsystem (MSS) provides a GPIO hard peripheral (APB_1 sub bus) with 32 configurable GPIOs. The actual behavior of each GPIO (input, output and output enable register controls, interrupt modes, etc.) can be…

Brand: Microsemi