Ta kin 1:10th Scale Crew Cab
Product Specifications
- Scale: 1:10
- Recommended Axle and Shocks Length: Rear 120-130mm, Front 90-100mm
- Spacers Required: 3-6mm for AR-60 Axles
Product Usage Instructions
Assembly Instructions:
Follow the steps below to assemble the product:
- Trim the drive shafts to a length of 25-30mm.
- Mount the motor using the included screws (M3x8mm Flat x2, M3x10mm Flat x3).
- Attach the battery tray and transmission cover.
- Route the receiver/power button cables (M2.5x8mm Flat x2, M3x10mm Flat x3, M2.5x8mm Flat x2).
- Position the main frame and receiver, and temporary position the power button.
- Assemble the rear tire mount, bulkhead assembly, fan wiring, and airbox assembly.
- Affix the frame to the floor.
- Install the lead and trail arms, bumper, axles, and cab.
- Mount the internal winch servo and internal wiring.
- Position the axles and shocks according to specifications.
- Install the crew seats and secure them in place.
- Slide the cab into place and reassemble the front shock mounts.
- Confirm wiring and functionality of the product.
- Install steering components and dash.
- Wire LEDs accordingly for fog lights/signals and adjust magnetic hatches.
Frequently Asked Questions
- Q: How do I adjust the magnetic hatches?
- A: To adjust the magnetic hatches, use an M3 screw to meet the required position securely.
- Q: What size spacers are required for AR-60 axles?
- A: Spacers of 3-6mm thickness are required to position AR-60 axles correctly.
Installation Instruction
Documents / Resources
 |
Ta kin 1:10th Scale Crew Cab [pdf] Instruction Manual 1 10th Scale Crew Cab, Scale Crew Cab, Crew Cab, Cab |