Szaoju Wireless Remote Switch

Specifications
| Chipset Compatibility | 2260, 2262, PT2264, 2240, 5326, SC5262, HT600, HT6P20B, HT6P20D, HT680, HT6207, HT6010, HT6012, HT6014, SMC918, 527, 1527, 2240, HCS101, HCS200, HCS201, HCS300, HCS301 |
|---|---|
| Microcontroller Section | Part of single chip |
Examples of Copy able Chips
- 2260 (all manufacturers)
- 2262 (all manufacturers)
- PT2264/2240/5326 (all manufacturers)
- SC5262, HT600/HT6P20B/HT6P20D/HT680/HT6207/HT6010/HT6012/HT6014, SMC918 Series, 527 (all manufacturers)
- 1527 (all manufacturers)
- 2240 (all manufacturers)
- HCS101/200/201 (part of the code)
- HCS300/301 (part of the code)
INSTALLATION INSTRUCION
Instructions for Duplicating and Copying
Clear Code
- Delete the original code on the copied remote control.
- Press and hold the “A” and “B” buttons simultaneously until the LED light flashes for 3 seconds.
- Release the “B” key, and continue pressing the “A” key to copy other codes.
Copy the Code
- Place the copy remote control next to the original remote control.
- Press and hold the “A” button on the copy remote control until the LED light flashes rapidly.
- Press twice to enter the copy mode, then press the original remote control.
- Press the “A” button until the LED light on the copy remote control remains on.
- Release the two buttons to complete the code copying (use the same procedure for other codes).

Complete Code
When copying other remote controls, the code reset settings can be released after:
- To copy the code quickly, simultaneously press and hold the “C” key and “D” key for 3 seconds.
- Press and hold for 3 seconds. The LED light must remain on; then release the buttons.

The chipset compatibility Duplicator Remote User Manual
- 2260(All the manufacturers) 2262(All the manufacturers) PT2264/2240/5326(All the manufacturers)
- SC5262,HT600/HT6P20B/ HT6P20D/HT680/HT6207/ HT6010/HT6012/HT6014, SMC918 Series, 527(Al the manufacturers)
- 1527 (All the manufacturers)
- 2240(All the manufacturers)
- HCS101/200/201(Parts of code)
- HCS300/301(Parts of code)
- Parts of single chip..
Copy Way
(Clear the history code from duplicator)
- Press button “A” and” B” at the same time until LED flash 3 times
- Release button” B” and Keep pressing
- Release button” A”, finish code clearance
Duplicating
(Copy code from original transmitter)
- Put duplicator aside of original transmitter ,as close as possible.
- Press and hold button “A” of original transmitter, then press and hoed button “A” of duplicator until you see the duplicator’s LED flash and keep lighting
- Release both buttons ,finish code copy, button “A”, then press button “B” 3times copy other button in same way.
- Release button” A” ,finish code clearance
Resume
Press and hold button “C” and “D” for 3 seconds, the LED flash, all buttons reteam back to the latest copy codes.
Documents / Resources
![]() | Wireless Remote Switch |
References
- User Manualmanual.tools
Published: June 16, 2026

