systemair 24807 EC-BASIC-H Humidity Controller logo

systemair 24807 EC-BASIC-H Humidity Controller

systemair 24807 EC-BASIC-H Humidity Controller product

Description

  • Simple to install, connect and set up
  • 50/60HZ mains option
  • Can be used with all 220V single phase and 380V three phase EC fans
  • Built in sensor
  • Conforms to CE standards EN 60730-1, EN 61000-6-3, EN 61000-6-1
  • Demand control made simple

The controller compares room humidity with an adjustable set point (SW1) and regulates a 0..10 V output signal applied to a ventilator with a proportional algorithm in direct or reverse action based on jumper JP1 setting:

  • JP1 closed 1-2 = reverse action
  • JP1 closed 2-3 = direct action

Technical parameters

Voltage85-265V
Frequency50/60Hz
Power consumptionmax 0,46W
Temperature range-20-50°C
Humidity measurement range0-100%RH

Dimensions

systemair 24807 EC-BASIC-H Humidity Controller 01

Accessories

Documentation

  • IMO_EC-BASIC_EN_SV_rev3.pdf (1,42MB)
  • 24807_Declaration of Conformity_EN.pdf (127,33kB)

Wiring

systemair 24807 EC-BASIC-H Humidity Controller 02

Puravent, Adremit Limited, Unit 5a, Commercial Yard, Settle, North Yorkshire, BD24 9RH
Call: 0845 6880112
Email: info@adremit.co.uk

Documents / Resources

systemair 24807 EC-BASIC-H Humidity Controller [pdf] Instructions
24807 EC-BASIC-H Humidity Controller, 24807, EC-BASIC-H Humidity Controller, Humidity Controller, Controller

References

Leave a comment

Your email address will not be published. Required fields are marked *