SYNCMIC Ai Mini Printer Instruction Manual

SYNCMIC Ai Mini Printer

Key introduction

Power button: Press and hold for 3 seconds to turn on/off the device.

AI Button:

1. Long press to trigger the generation of a visual effect based on the sound, short press to return to the style mode.
2. Click to switch the style mode.
3. Double-click to print the APP QR code.

Print button: Press briefly after generating the image to start the printing process.
Reset hole: If the device freezes and cannot be powered on, you can use a sharp object to rub it.

APP Download &Device Connection Steps

Download the APP

1. Method 1: Scan the QR code below and follow the on-screen instructions to download the corresponding App;
2. Method 2: Search for “Friend Al” in the official app storeon your mobile device, then download and install the app. IPhone: Open the App Store, search “Friend Al” and  install ;Android: Open your app store or Google Play, search “Friend Al” and install.

((Note: 5G WiFi is not currently supported)

Create content
Hold down the [Ai] key to talk – Create content. After the network is successfully set up, the page displays the words “Press to talk” .At this time, you can press and hold the [Ai] button at the top of the device for a creative experience. For example: “Print a of a little dog running in the field”.Specific operation: press and hold the [Ai] key with out releasing it – speak the command – release the key after the command, and the print will be displayed.

Battery warning note

1. Please use 5V charger to charge according to the specification to avoid damage to the machine.
2. Disassembly, impact, extrusion or fire are prohibited;
3. If severe bulging occurs, do not continue to use;
4. Do not put in high temperature environment, battery after immersion is prohibited to use;
5. Replacement with the wrong type of battery can be explosive, be sure to follow the instructions to dispose of used batteries.

Matters needing attention

1. When charging, please gently insert or unplug the charging cable to prevent excessive force from damaging the port;
2. After charging, please unplug the charging calebin time;
3. To avoid danger, do not use or charge IN environments with hightemperature, high humidity ,excessive smoke and dust, such as: bathrooms, steam rooms, open flames, etc.;
4. Improper charging may cause damage to the printhead;
5. Do not touch the print head to prevent overheating and burns;
6. The tearing blade is sharp, be careful not to touch it.

FCC Warming:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. lf this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.