Elecrow ESP32 AI Camera Development Board Vision Sensor Board

Sehemu za Kifaa

1. Kichwa cha Spika
2. Mwangaza wa RGB
3. Kitufe cha Al
4. MIC
5. Kichwa cha UART
6. Yanayopangwa Kadi ya TF
7. Kamera
8. Mwanga Msaidizi
9. Weka Kitufe Upya
10. Spika
11. Bandari ya Aina ya C
12. Nuru ya Nguvu
13. Mwanga wa Betri
14. BAT Header

Mwongozo wa Haraka

• Al Button:
  • In “Al Voice” mode, click to toggle the “Standby/Listening” status.
• Weka Ufunguo Upya:
  • Single-click to reboot after firmware flashing failure or device malfunction.
• Nuru ya Nguvu:
  • The red LED is on steadily when powered.
• Mwanga wa Betri:
  • When powered by the battery, the red light stays on while charging, and the green light stays on when fully charged.

Kuoanisha Mtandao

1. Plug in the Type-C cable to power on.
2. If you want to use the “Al Online” feature, you need to network pair and register the Al Agent first.
3. Open your phone/computer’s WiFi list, click on “Al_Camera_XXXX” to enter WiFi pairing mode.
   • Ikiwa webpage does not open automatically, please visit 192.168.4.1 in your browser.
4. Choose an available 2.4GHz WiFi, enter the WiFi password, and click “Save Configuration”.
   • You can see your Wifi in “WiFi Network”.
   • Kumbuka: If you want to clear your network, open the “Settings” app, then open the “Configure Network”, and click “RECONFIGURE”.
5. Open the “Al Online” app, then open a browser and go to https://portal.thinknode.cc/ to access the Al Hub interface. If this is your first time logging in, you need to click the “Create Account” button to create an account.
6. After the account is successfully created and logged in, you will receive a 5000-point reward.
7. Click the “Al Hub” button to start “Add Agent”.
8. Click “Add Agent” and give your Al Agent a name.
9. Click “Manage devices (0)”, then click “Add Device”, enter the verification code, and confirm.
10. After completing “Add Device”, you can configure the character.
11. If you want to browse “Historical conversations”, you need to first enable “Local Short-term Memory” and save.
    • Kumbuka: If your 5000 points are used up, you need to click “Recharge” to purchase a plan that will allow you to regain points.

Specifications Kuu

• Jina la Bidhaa: Al Camera Module
• Mdhibiti Mkuu ESP32-S3R8
• Onyesho 1.83-inch TFT-LCD Touch Screen
• Pixels 2 Mbunge
• Bila waya WiFi & Bluetooth 5.0
• Mwako 16MB
• Yanayopangwa Kadi ya TF Inaauni hadi 128GB
• Kiolesura UART Interface. IC Pad
• Ingizo 5V/1A
• Vipimo 56.05*44.5*18.6mm
• Joto la Uendeshaji -20°C hadi 65°C

Nyaraka / Rasilimali

Elecrow ESP32 AI Camera Development Board Vision Sensor Board [pdf] Mwongozo wa Mtumiaji ESP32 AI Camera Development Board Vision Sensor Board, ESP32, AI Camera Development Board Vision Sensor Board, AI Camera Development Board Vision Sensor Board, AI Camera Development Board, Camera Development Board, Vision Sensor Board, Sensor Board

Marejeleo

• Mwongozo wa Mtumiaji