SVP-logo

SVP 607620 Bandpass Filters

SVP 607620 Bandpass Filters-fig1

Content

  1. Overview
  2. Trim Points Layout
  3. Trim Tools
  4. Trim Points

    Warnings

    • Please read the Safety and Operation document.
    • Do not attempt to act on the Trim Points to tune or re-tune a Filter unless you are familiar with Bandpass Filter tuning. A tuned Filter can be easily mistuned, with no easy possibility to roll-back, with few and limited movements on the Trim Points.
    • Do not start tuning or re-tuning a Filter prior to carefully reading both its User Manual and Tuning Instruction. Permanent damage may occur.

Overview

SVP 607620 Bandpass Filters-fig2

Trim Points Layout

SVP 607620 Bandpass Filters-fig3

Trim Tools

SVP 607620 Bandpass Filters-fig4

Trim Points

SVP 607620 Bandpass Filters-fig5

Input / Output Couplings (KEI / KEO)

  1. Tune: Trim the Coupling screw (4 mm Allen) according to the Tuning Instructions.
    • Turning the Coupling screw clockwise the coupling increases, and vice versa.

Tunings (T1, T2…)

SVP 607620 Bandpass Filters-fig6

  1. Open: Manually unscrew and remove the red lid.
  2.  Tune: Trim the Tunings screw (4 mm Allen) according to the Tuning Instructions.
    • Turning the Tuning screw clockwise the tuning frequency decreases, and vice versa.

      Warnings

    • Use caution when approaching the end of stroke on both sides of the Tuning screw: risk of permanent damage in case of forcing.
    • Never use electric screwdrivers or drills on the Tunings.
  3. Close: Manually screw the red lid.
    • The Tunings screws are frictioned, and they do not have any locking.

Documents / Resources

SVP 607620 Bandpass Filters [pdf] User Manual
607620, Bandpass Filters, 607620 Bandpass Filters

References

Leave a comment

Your email address will not be published. Required fields are marked *