Product Usage Instructions

IR Remote Functions

• Brightness + / Pause / Resume: Adjust brightness, pause, or resume light effects.
• Power ON / OFF: Turn the controller on or off.
• Color Presets: Choose from pre-set color options.
• DIY Adjust / Save: Customize colors by selecting one of the six DIY buttons. Use color arrows to adjust saturation. Hold a DIY button to save the custom color.
• Quick / Slow: Speed up or slow down selected lighting modes.

Wiring DiagramThe DC Barrel Connector serves as the input for power. Follow the wiring diagram provided for proper installation.

Lighting Modes

• Auto: Cycles through all modes randomly.
• Flash: Toggle strobe mode on or off.
• Fade7: Seven-color fade effect.
• Fade3: Three-color fade effect.
• Jump7: Seven-color instant change effect.
• Jump3: Three-color instant change effect.

Battery SafetyFor battery safety, refer to the specified battery type and handle with care to prevent damage or injury.

INTRODUCTION

Important: Read all instructions prior to installation.

Specifications

• The output power will not exceed the input power.

IR Remote

SAFETY INSTRUCTION

WARNING: INGESTION HAZARD

• This product contains a button cell or coin battery.
• DEATH or serious injury can occur if ingested.
• A swallowed button cell or coin battery can cause Internal Chemical Burns in as little as 2 hours.
• KEEP new and used batteries OUT OF REACH of CHILDREN Seek immediate medical attention if a battery is suspected to be swallowed or inserted inside any part of the body.

Wiring Diagram

Battery Safety

• Remove and immediately recycle or dispose of used batteries according to local regulations and keep away from children. Do NOT dispose of batteries in household trash or incinerate.
• Even used batteries may cause severe injury or death.
• Call a local poison control center for treatment information.
• Non-rechargeable batteries are not to be recharged.
• Do not force discharge, recharge, disassemble, heat above (manufacturer’s specified temperature rating), or incinerate. Doing so may result in injury due to venting, leakage, or explosion, resulting in chemical burns.
• Ensure the batteries are installed correctly according to polarity (+ and -).
• Do not mix old and new batteries, different brands or types of batteries, such as alkaline, carbon-zinc, or rechargeable batteries.
• Remove and immediately recycle or dispose of batteries from equipment not used for an extended period of time according to local regulations.
• Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep them away from children.

Customer Service

• Rev Date: V2 05/29/2024
• 4400 Earth City Expy, St.
• Louis, MO 63045
• 8665903533
• superbrightleds.com