Super Bright LEDs BRI619 0-10 Volt Low Voltage PIR Motion Sensor
Safety and Notes
- The product should be installed and serviced by a certified electrician in accordance with applicable national, state, and local building and electrical codes.
- To reduce the risk of electric shock, ensure that the main power source and circuit breakers are switched off before performing any installation or wiring procedures.
Specifications
| Model | BRI619 |
| Maximum Detection Radius | 29.5 ft (9 m) |
| Maximum Mounting Height | 39.4 ft (12 m) |
| Operating Temperature | -40°–167° F (-40°–75° C) |
| Dimming | 0–10 V¹ |
Default Settings
| Model | Sensitivity | Hold On Time | Daylight Sensor | Dimming Level | Dimming Time |
| BRI619 | 100% | 15 min | 30 lux | 30% | 60 minutes |
DIP Switch Settings
| Setting | Sensitivity | Time | Light | Standby Level | Standby Time |
| Switch Pair Position | 1 and 2 | 3 and 4 | 5 and 6 | 7 and 8 | 9 and 10 |
|
|
20% |
10 seconds |
disabled |
0% |
always on |
|
|
50% |
1 minute |
10 lx |
10% |
1 minute |
|
|
75% |
5 minutes |
30 lx |
30% |
30 minutes |
|
|
100% |
15 minutes |
50 lx |
50% |
60 minutes |
- Sensitivity adjusts detection range.
- Time adjusts the amount of time before the light enters standby mode when no motion is detected.
- Light adjusts the ambient light threshold (photocell operation).
- Standby Level adjusts the dimming level in standby mode.
- Standby Time adjusts the amount of time between entering standby mode and fully disabling light.
Motion Sensor
Installation
- Remove supply power from
- Remove two bolts to open access
- Drill 1 5/16 in. hole in pre-marked
- Place module through hole, then install rubber gasket and locking
- Plug sensor into
- Wire using wiring diagram
- Close and secure panel then reapply supply.
Wiring Diagram
Note: Sensor uses 12–24 VDC input only
Documents / Resources
 |
Super Bright LEDs BRI619 0-10 Volt Low Voltage PIR Motion Sensor [pdf] User Manual BRI619, 0-10 Volt Low Voltage PIR Motion Sensor |
