super bright LED HBR3-RM Remote for Dimmable Sensors

Attention

1. f you want to send a seting.it will only work if the remote control is on. if you don’t press any button within 10 seconds, the indicator light will go out.
2. When using “ON/OFF” button, the rest buttons except the “ON/OFF”,”BRIGHTNESS” and ‘SEND” buttons will be disabled.
3. When using “TEST” button, the rest buttons except the “TEST, SENSITVITY ‘and “SEND” buttons will be disabled,
4. Every change needs to press “SEND” button ,it will be saved.
5. Because of the power supply DIMMING ratio difference, when using different power, “BRIGHTNESS” and STANDBY DIM adjust percentage of the power will have difference with the measured power.
6. Light control priority mode: the on offal amination values of each gear are 10bw/50k, 30bu/100bx, 50bW/150bx and 100bki200bx.
7. Light threshold mode: the on/off lamination values of each gear is 10k/30k50kl100x, when the light intensity is less than set value and the movement of someone or an object is induced, the light is timed on to the preset brightness.

Documents / Resources

super bright LED HBR3-RM Remote for Dimmable Sensors [pdf] Instructions HBR3-RM Remote for Dimmable Sensors, HBR3-RM, Remote for Dimmable Sensors, Dimmable Sensors, Sensors

References

• User Manual