STORM AUDIO ISP-ISR Immersive Sound Receiver
Connect your device
- Connect your AC cable to a grounded outlet and your RJ45 cable
- LAN cable to your local router. Connect your inputs and outputs to the processor.
- Power up your unit, and the display will show the StormAudio icon for a few seconds.
- When the LED turns steady red, press the power button and wait until it becomes steady GREEN.
Access the configuration page.
Type stormaudio. Local into the address bar of a web browser to get access to the web user interface.
More than one StormAudio processor in your network?
If you already have a StormAudio device in your room, you need to access the web user interface with the IP address of the product. To know how to find your IP address, please scan the QR code below to read our dedicated article or refer to the StormAudio local owner’s manual.
Find your IP address.
Start configuration
- Select your configuration mode.
- Enter the password.
- Follow the on-screen instructions to complete the setup.
Get training
Extend your knowledge by exploring the extensive training resources on StormAudio products available on our website. If you require technical support, please first contact your reseller.
Direct link to the owner’s manual
IMPORTANT SAFETY INSTRUCTIONS
The book symbol means: Read the owner’s manual before installation and use.
The lightning flash warns of dangerous voltage inside the product that can cause an electric shock.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPARATUS TO RAIN OR MOISTURE.
The exclamation point signals important operating and maintenance (servicing) instructions in the literature accompanying the product. The wave symbol next to the voltage information (100V-240V 50/60Hz) is intended to alert the user that the nit should be powered by an alternating current (AC) source, so-called mains power outlet, of the electrical installation.
Immersive Audio Technologies hereby declares that this equipment complies with the EMC 2014/30/ UE Directive, LVD 2014/35/UE Directive, ErP 2009/125/CE Directive, and RoHS 2011/65/CE Directive, EN 62368-1 Directive, EMC Emission Directive EN 55032, EMC Immunity Directive: EN 5503,5 and Testing methods EN 61000-x.
Sébastien Gailleton, Head of Product
- Read and follow all instructions. Keep the manual.
- Heed all warnings.
- Do not use this apparatus near water or expose it to dripping or splashing. Avoid placing objects filled with liquid on the unit.
- Clean only with a dry cloth.
- Do not block any ventilation openings. Install according to the manufacturer’s instructions.
- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
- Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades, with one wider than the other.
- A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. Protect the power cord from being walked on or pinpinchedarticularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
- Only use attachments/accessories specified by the manufacturer.
- Use only with the cart, sstandardtripod, bracket, or table specified by th manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from a tip-over.
- The apparatus weight exceeds 13 kg, which could drop and cause serious injuries. Move the apparatus with care.
- Unplug this apparatus during lightning storms or when unused for long periods.
- Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as the power-supply cord or plug is damaged, liquid has been spilled, objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. - Do not open. No user serviceable parts inside.
- To completely disconnect this equipment from the AC mains, disconnect the power supply cord plug from the AC receptacle.
- The mains plug of the power supply cord shall remain readily operable.
- For safety and electrical shock reasons, it is Recommended to use this device in a non-tropical environment with temperature not exceeding 45°C and altitude not exceeding 2000m.
- Do not expose batteries to excessive heat, such as sunshine, fire,e, or the like.
WARRANTY
Liability
The legal guarantees of conformity under no circumstances cover any damage arising from accidents, misuse, assembly error, negligence, or considerable modification of the appearance or functioning of the product. Immersive Audio Technologies reserves its right to refuse any return for a damaged product on account of misuse.
Terms of warranty
All StormAudio products are covered by a warranty drawn up by the official StormAudio distributor in your country. Your distributor can provide all details concerning the conditions of warranty. Warranty cover extends at least to that granted by the legal warranty in force in the country where the original purchase invoice was issued.
Warranty is valid only in the country where the product was originally sold. StormAudio reserves the right to refuse the free application of the warranty if a copy of the invoice stating purchase date, model, and serial number is not presented. To prevent any damage or loss/deletion of data stored on the device, you must have saved it before returning your device to the services responsible hereunder, using the Backup Configuration feature available in the System page.
Transport cost to mainland France or other official technical centers is at the expense of the customer. The device is transported at the risk of the customer. We strongly recommendstoringe the original packaging for any transportation. In the event of any damage observed upon its return, all the reservations must be made by the recipient with the carriers.
REGULATIONS
FCC and IC compliance notice
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This Class B digital apparatus complies with Canadian ICES-003.
WEEE Notice
This product must not be disposed of with household waste. Dispose of this product at a collection point for the recycling of electrical and electronic equipment. For more information, please contact your
local authorities or the retailer where you purchased this product.
RoHS Compliance
This product is in compliance with Directive 2011/65/EU of the European Parliament on the restriction of the use of certain hazardous substances in electrical and electronic equipment.
ACKNOWLEDGMENTS
This product includes software components licensed under proprietary licenses. For more information regarding the licenses and terms of use, please refer to the owner’s manual or visit www.stormaudio.com.
Download our
Storm Remote control app
www.stormaudio.com
Download our
StormAudio | Immersive Audio Technologies
8 rue de la Rabotière | 44800 Saint-Herblain | France
Documents / Resources
 |
STORM AUDIO ISP-ISR Immersive Sound Receiver [pdf] User Guide 2025, ISP-ISR Immersive Sound Receiver, ISP-ISR, Immersive Sound Receiver, Sound Receiver, Receiver |
