stepsolution Unfinished White Oak Riser Installation Guide

Tools & Materials Needed

• Urethane Construction Adhesive (recommended)
• Caulking gun
• Measuring tape
• Saw (miter or circular)
• Level
• Cloth or sponge (for cleaning excess adhesive)

Installation

Step 1: Prepare the Surface

• Remove any existing material (carpet, debris, nails, glue, etc.)
• Ensure the riser surface is clean, dry, and flat
• Lightly sand if needed for better adhesion

Step 2: Measure Each Riser

• Measure width and height of each step individually
• Do not assume all steps are the same size

Step 3: Cut the Riser

• Cut the white riser to the correct width
• Dry-fit the piece to ensure proper fit before applying adhesive

Step 4: Apply Adhesive

• Apply urethane construction adhesive in continuous horizontal lines
• Apply on the back of the riser panel
• Do not overapply to avoid squeeze-out

Step 5: Install the Riser

• Press the riser firmly against the vertical face of the step
• Make sure it sits flush and level
• Hold in place for a few seconds to ensure proper bonding

Step 6: Clean & Secure

• Wipe away any excess adhesive immediately
• If needed, apply light pressure or weight while adhesive sets

Step 7: Cure Time

• Allow adhesive to cure for at least 24 hours before heavy use

Important Tips

• Always install the riser BEFORE the stair tread
• Product is designed for indoor use only
• For best results, work step-by-step rather than installing all at once
• Available in 1/4″ and 1/2″ plywood thickness options