ST402 RGB LED Controller
“
Product Information
Specifications:
- FCCID: 2BMS8-ST402
- Input: DC 5-24V
- Output: 5
- Device Type: RF Remote Control Kit
Product Usage Instructions
Safety Precautions:
1. Do not make any changes or modifications to the device that
are not explicitly approved by the manufacturer.
2. Ensure that the device is operated in compliance with FCC
Rules to prevent harmful interference.
3. Maintain a minimum distance of 0cm between the radiator of
the equipment and your body during installation and operation.
Installation:
- Connect the device to a power source within the specified input
range of DC 5-24V. - Follow the manufacturer’s instructions to set up the RF Remote
Control Kit. - Place the equipment in a suitable location for optimal signal
reception.
Operation:
- Use the RF remote control provided with the kit to operate the
device. - Follow the user manual for specific functions and
controls. - Ensure that the device does not cause interference with other
electronic equipment.
FAQ
Q: What should I do if the device is not responding to the
remote control?
A: Check the batteries in the remote control and ensure they are
properly inserted. Also, verify that there are no obstructions
blocking the signal between the remote and the device.
Q: Can I use this device in an outdoor environment?
A: The equipment should be installed and operated in an
uncontrolled environment according to FCC radiation exposure
limits. Ensure proper protection from environmental factors if used
outdoors.
“`
FCCID:2BMS8-ST402
DC 5-24V 5
RF Remote Control Kit
FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment generates, uses and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipment does cause harmfulinterference to radio or television reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0cm between the radiator and your body.
Documents / Resources
 |
STTEAM ST402 RGB LED Controller [pdf] Instruction Manual 2BMS8-ST402, 2BMS8ST402, st402, ST402 RGB LED Controller, ST402, RGB LED Controller, LED Controller, Controller |
