P4DD46A2-KVM-SWITCH KVM Dual Monitor KVM
Switch Instructions
Product IDs
P2DD46A2-KVM-SWITCH
P4DD46A2-KVM-SWITCH
Product Information
For the latest software, manuals, product information, technical specifications, and declarations of conformance, please visit:
www.StarTech.com/P2DD46A2-KVM-SWITCH
www.StarTech.com/P4DD46A2-KVM-SWITCH
Hotkey Commands
Hotkey commands are keystroke sequences that initiate computer/device functions and can be used to initiate KVM Switch functions. A hotkey command sequence must be initiated by the HK_LCode (HotKey Leading Code), followed by 1-2 additional keystrokes. Successful hotkey command inputs result in a high-pitch beep. Unsuccessful hotkey command inputs result in a low-pitched beep.
Notes:
- All keystroke combinations must be entered in rapid succession.
- Press and release the indicated keys, unless otherwise specified.
HK_LCode
Option 1.1
- Scr Lck + Scr Lck
Option 1.2
To change the HK_LCode:
- HK_LCode + H + Esc, Caps, or F12
- Alternatively, press and hold the front Host Selection Button for PC2, until 2 beeps are emitted, then press the desired leading hotkey of Scr Lck, ESC, Caps, or F12
| Hotkey Command | Function |
| HK_LCode + 1 ~ 2 or HK_LCode + F1 ~ F2 |
• Select PC 1 or PC 2. |
| HK_LCode + W | • Disable the binding between PC (USB/Video) and Audio when switching between PC 1 or PC 2. • Allows switching of PC Ports USB and Video functions, while Audio does not switch |
| HK_LCode + Q | • Enable the binding of PC (USB/Video) and Audio switching. • Audio will switch with the PC Ports USB and Video functions. • Enabled by default. |
| HK_LCode + F5 ~ F6 | • Audio Unbound: Selects only the audio and mic source between PC 1 or PC 2, does not switch USB and Video • Audio Bound: Select PC 1 or PC 2 and their respective USB/Video/Audio Ports |
| HK_LCode + Up Arrow Key or HK_LCode + Down Arrow Key |
• Select the next/previous PC Port. • If Audio is unbound, the audio will not switch |
| HK_LCode + B | • Disable the Beep that indicates HotKey Command Inputs. |
| HK_LCode + S | • Enable Autoscan. • Press any key to stop the Autoscan function. |
| HK_LCode + H + “x” | • Define the Autoscan time delay. • “x” = 1 – 10sec, 2 – 20sec, 3 – 30sec, 4 – 40sec, 5 – 50sec, 6 – 60sec, 7 – 70sec, 8 – 80sec, 9 – 90sec, 0 – 100sec |
To view manuals, FAQs, videos, drivers, downloads, technical drawings, and more, visit www.startech.com/support.
Hotkey Command Revision: May 11, 2023
Documents / Resources
 |
StarTech P4DD46A2-KVM-SWITCH KVM Dual Monitor KVM Switch [pdf] Instructions P2DD46A2-KVM-SWITCH, P4DD46A2-KVM-SWITCH, P4DD46A2-KVM-SWITCH KVM Dual Monitor KVM Switch, P4DD46A2-KVM-SWITCH KVM, Dual Monitor KVM Switch, Monitor KVM Switch, KVM Switch, Switch |
