Stack TL-100 Traffic Light Remote Programing
PROGRAMING INSTRUCTIONS
- Remove the panel from the bottom LED to locate the Receiver PCB.
- Press The Small Black Button on the Receiver. (LED will turn on)
- Press Button to be programmed on the Remote. (LED will start blinking)
- Wait until LED stops Flashing.
- Press Remote Button Again.
- Repeat for other Remote Buttons to be programmed.
CUSTOMERS SUPPORT
For Help call Stack Light.com at 678-288-9678
Documents / Resources
 |
Stack TL-100 Traffic Light Remote Programing [pdf] Instructions TL-100 Traffic Light Remote Programing, TL-100, Traffic Light Remote Programing, Light Remote Programing, Remote Programing, Programing |
