AutoHot WT100 Wireless Temperature Sensor

Litlhaloso

• Ho latela melao: FCC Karolo ea 15
• Sehlopha: Sesebelisoa sa dijithale sa Sehlopha sa B
• Litaelo tsa ho pepeseha ha RF: Maintain a 20cm distance between the radiator and the body
• Antenna: Antenna e fanoeng

Wireless Temperature Sensor

The wireless temperature sensor is designed to monitor water temperature and communicate with the system’s controller. It features a digital display, adjustable settings, and multiple signal types to ensure efficient operation of the water pump.

1. Pontšo ea Dijithale ea LED
2. Sensora ea Mocheso
3. Setting Button
4. Forward Button (adjusts temperature up)
5. Backward Button (adjusts temperature down)
6. Boema-kepe ba USB ba Mofuta oa C
   1. Pair the wireless temperature sensor before the crossover gets installed, following the instructions below.
   2. Install crossover hardware under the sink and place the wireless temperature sensor onthe  wall with double-sided tape

Likaroloana

• Pontšo ea Dijithale: Shows real-time temperature and signal types.
• Temperature Detection Frequency: Metsotsoana e meng le e meng e 3.
• Adjustable Lockout Temperature Range: 700°F to 1300°F (default 1050°F).
• Adjustable Delta Range: Temperature change every 3 seconds can be set between 20°F and 140°F (default delta: 60°F). Display format is “d” followed by a 2-digit number.

Signal Types Displayed

• “L” = Low Water Temperature
• “H” = High Water Temperature
• “CD” Over Delta Temperature

Operational Behavior
When the water temperature reaches the lockout temperature, the sensor sends a “high water temperature” signal (“H”) to the controller, stopping the pump and turning the LED indicator on solid. The controller blinks rapidly for 2 seconds upon receiving any signal. If the temperature change exceeds the delta within 3 seconds, an “Over delta” signal (“OD”) is sent, stopping the pump and turning the LED indicator on solid. When the temperature drops below the lockout temperature minus the delta (e.g., with a 1050°F lockout and an SF delta, the threshold is 1000°F), a “low water temperature” signal (“L”) is sent, turning off the LED on the controller.

Power Options & Low Power Alert
3 AA alkaline batteries or a Type-C USB with a DC 5V power supply. Makes a “beep” low-power alert when the voltage ka tlase ho 3V.

Range

• Wireless sensor to controller: up to 660 feet in open air.
• Wireless sensor to signal repeater: up to 450 feet in open air.

Litlhophiso tsa mosebetsi

Setting Lockout Temperature

1. Press and hold the “Setting button” for 3 seconds; the LED display will flash the current lockout temperature.
2. Use the “Forward” or “Backward” button to adjust the temperature. Holding the buttons will change the value faster.
3. Press the “Settings button” again to confirm and exit.
   • Checking Current Temperature: Short-press the “Setting button” to display the real-time temperature for 10 seconds.

Pairing and Manual Activation
Used for pairing the wireless temperature sensor with the controller. Short-press the “Setting button” to display the real-time temperature, then press again to show “L” (low water temperature signal). After the controller receives the signal, pairing is complete.

Delta Setting:

1. Press and hold the “Backward button” for 3 seconds to display the current delta.
2. Use the “Forward” or “Backward” button to adjust.
3. Press the “Settings button” to confirm and exit.

TLHOKOMELISO FCC

Sesebelisoa sena se lumellana le karolo ea 15 ea Melao ea FCC. Ts'ebetso e ipapisitse le maemo a mabeli a latelang:

1. Sesebelisoa sena se ka 'na sa se ke sa baka tšitiso e kotsi, le
2. Sesebelisoa sena se tlameha ho amohela tšitiso efe kapa efe e amohetsoeng, ho kenyeletsoa tšitiso e ka bakang ts'ebetso e sa batleheng. Liphetoho leha e le life kapa liphetoho tse sa amoheloang ka ho hlaka ke mokha o ikarabellang bakeng sa ho lumellana le melaoana li ka senya matla a mosebedisi a ho sebelisa thepa.

HLOKOMELA
Thepa ena e lekiloe 'me e fumanoe e lumellana le meeli ea sesebelisoa sa digital sa Sehlopha sa B, ho latela Karolo ea 15 ea Melao ea FCC. Meeli ena e etselitsoe ho fana ka tšireletso e utloahalang khahlanong le tšitiso e kotsi mohahong oa bolulo. Thepa ena e hlahisa, e sebelisa, 'me e ka khantša matla a maqhubu a seea-le-moea, 'me haeba e sa kengoa le ho sebelisoa ho latela litaelo, e ka baka tšitiso e kotsi likhokahanong tsa radio. Leha ho le joalo, ha ho na tiiso ea hore tšitiso e ke ke ea etsahala setsing se itseng. Haeba sesebelisoa sena se baka tšitiso e kotsi ea seea-le-moea kapa kamohelo ea thelevishene, e ka lekanyetsoang ka ho tima le ho tima sesebelisoa, mosebelisi o khothalletsoa ho leka ho lokisa tšitiso ka e le 'ngoe kapa tse ling tsa mehato e latelang:

• Sheba hape kapa o suthise lenakana le amohelang sebakeng se seng.
• Eketsa karohano pakeng tsa thepa le moamoheli.
• Hokela lisebelisoa sebakeng sa seketsoana se fapaneng le seo moamoheli a hokahaneng le sona.
• Ikopanye le morekisi kapa setsebi sa radio/TV se nang le boiphihlelo bakeng sa thuso.

To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with a minimum 20cm distance between the radiator and your body: Use only the supplied antenna. Contact Enovative Group Inc.: 866-495-2734 OR info@enovativegroup.com OR www.autohotusa.com

FAQs

P: A na nka sebelisa antenna e fapaneng ka sesebelisoa?
A: It is recommended to use only the supplied antenna to ensure compliance with FCC regulations and proper operation of the device.

P: Ke lokela ho etsa eng haeba ke ba le tšitiso ea seea-le-moea?
A: If you experience radio interference, try adjusting the placement of the device and ensure it is operating as per the user manual instructions. If issues persist, contact customer support for further assistance.

Litokomane / Lisebelisoa

AutoHot WT100 Wireless Temperature Sensor [pdf] Buka ea Taelo WT100, WT100 Wireless Temperature Sensor, Wireless Temperature Sensor, Temperature Sensor, Sensor

Litšupiso

• Bukana ea Mosebelisi