SSV Works 11-20 CAN-AM COM1000XT 4, Speaker
SPECIFICATION
- DIMENSIONS: 5 x 5 x 5 inches
- WEIGHT: 25.2 pounds
- SPEAKER TYPE: Soundbar
- SIZE:5”
INTRODUCTION
The first company to incorporate audio in side-by-sides is SSV Works. All of the wonderful features found in audio systems today were invented by us. SSV has established the benchmark in UTV audio from the very beginning, setting the bar for plug-and-play kit solutions, true waterproof ratings, and factory fit and finishes.
An excellent entry-level system that installs quickly is one of our WP Overhead Systems! All you need to do is slip the enclosure into your factory cage, run the power and ground connections, and you’re ready to go! The speakers and MRB3 Bluetooth Media Unit are already installed.
WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1-year warranty against defects in material or workmanship. All SSV Works Speakers are covered by a limited 1-year warranty against defects in material or workmanship. Labor for replacement of defective components is not covered. Contact SSV Works for further warranty information.
Please read and understand these instructions completely before installation to avoid possible injury, or damage to the accessory or vehicle.
TOOLS NEEDED FOR INSTALLATION
- Wire Crimpers
- Wire Strippers
- Wrench for Battery Terminal
- #3 Phillips Screwdriver
PARTS LIST
- WP3-CM04A x 1
- M6 x 1.0 Screws x 16
- M6 Washers x 16
- Mounting Brackets x 4
- Fuse Holder with Fuse
- Crimp on ring terminal
- Extension Power Wire & Zip Ties
INSTALLATION NOTES
Locate the battery in the vehicle before beginning the installation. Depending on the vehicle model and trim level the battery could be located either under dash to the left of the steering wheel, under the rear passenger seat or under the center of the bed. It is recommended to have another person assist with this installation. The use of a thread locker is recommended on all screws to prevent loosening due to vibration.
INSTALLATION INSTRUCTIONS
- With one person on either side of the vehicle place the WP3-CM04A into location from the underside of the cage.
- While holding the enclosure securely toward the front crossbar of the cage, loosely install the 4 brackets using the screws provided.
- Once the enclosure is centered side to side, press the bracket toward the center of the vehicle and tighten the brackets using the #3 screwdriver.
NOTE: After all brackets are tightened, it may be necessary to go back and re-adjust the brackets to ensure the enclosure is properly secured.
- Using the zip ties provided, route the Power/Ground loom to the battery location away from any moving parts or sharp metal. NOTE: The 4 pin short cable is for additional speakers and the 4 pin long cable is for adding an SSV Works Powered Subwoofer (Part# WP-CMS10)
WIRING INSTRUCTIONS
- Use the supplied extension power wire to complete your run from the WP3-CMO4A to your battery. Strip back 1/4”-1/2” of wire to make your connections.
- Crimp the supplied fuse holder onto the end of the RED wire and attach to the battery “+” terminal.
- Crimp the supplied ring terminal to the BLACK wire and attach to the battery “-” terminal.
FREQUENTLY ASKED QUESTIONS
Can I add 4 surround speakers to my soundbar?
Yes, you may upgrade your soundbar with wired speakers. It will be challenging, though, as soundbars are designed to stand alone. Because they were not designed with speaker outs, adding wired speakers requires the use of a receiver, stereo mixer, and RCA connections.
Is 3.1 or 4.1 soundbar better?
When compared to a 3.1 channel model, a 4.1 channel soundbar provides better quality without including options for surround sound speakers, unlike the 5.1 channel type. Instead of a single central speaker, a 4.1 channel soundbar typically features two frontal speakers.
How many speakers can you connect to a soundbar?
As many surround speakers as your receiver will support can be used. As long as your receiver permits it, you can create a 5.1, 7.1, 9.1, etc. sound system using this technique.
Is 2.1 or 5.1 sound bar better?
The best option for enhancing your TV sound without many speakers is 2.1, which is also the ideal option if you merely want to listen to music. The most popular choice for a home theatre audio experience is 5.1.
How many channels do I need for 4 speakers?
A four-channel amp may supply four speakers, two speakers, and a subwoofer by bridging two of the channels together to power the sub. It can also power four speakers, two speakers, and two rear full-range speakers.
Can I put 4 speakers on 2 channels?
When employing four speakers that are identical to one another, series wiring will produce the greatest results. Additionally, you must confirm that your 2-channel amp is of a good caliber and is more than capable of driving all four speakers simultaneously.
What size soundbar do I need for my TV?
Your new sound bar shouldn’t be broader than your TV from an aesthetic standpoint; in an ideal setting, both would be exactly the same width to provide a uniform appearance. A sound bar can, however, technically be paired with a TV of almost any size.
Do soundbars work as well as speakers?
While surround sound speakers often produce the highest audio quality, a soundbar will undoubtedly enhance the audio on your TV. Even the most expensive soundbars typically cannot match the expansive soundstage provided by speaker systems.
Are soundbars as good as speakers?
Soundbars can’t compete with the audio quality of speaker systems. Their size contributes to this in part. But it’s also because you can create true surround sound by dispersing speakers throughout a space. When viewing movies or playing video games, speaker sets are perfect for creating an immersive environment.
Are soundbars as good as surround sound?
Your living situation may determine whether you choose a soundbar or surround sound system. Due to their tiny size, soundbars are the best option for small apartments. However, surround sound installations will almost always offer a better listening experience if you have the room.
How many watts of soundbar is best?
By itself, a sound bar consumes 20–50 watts. The wattage rises if you have back speakers and subwoofers because you have more equipment.
Can I run 4 speakers off 1 channel?
A 4-zone speaker selector switch is the simplest and safest way to join 4 pairs of HiFi speakers. To wire this, all that is needed to do is run a wire from the living room, which serves as the hub, to each speaker. Additionally, any impedance matching should be taken care of by the box to avoid amplifier overload.
Is 2 way or 4-way speakers better?
Two parts, a tweeter for high frequency and a mid-range, make up a two-way speaker. The 4-way speaker is slightly better for high range sound than the 2 way since it has a bass and a mid-range component in addition to 2 tweeters, but it is not significantly better overall.
