Luceco EFDGUIPPC-01

Luceco LED IP65 противпожарна GU10 уградна светиљка са полираним хромом - упутство за употребу

Model: EFDGUIPPC-01

1. Увод

This manual provides essential instructions for the safe installation, operation, and maintenance of your Luceco LED IP65 Fire Rated GU10 Downlight. Please read this manual thoroughly before installation and retain it for future reference. This downlight is designed for recessed ceiling installation and features an IP65 rating, making it suitable for areas where protection against water jets is required, such as bathrooms (Zone 1 and 2) and outdoor sheltered areas. It also incorporates a fire-rated housing for enhanced safety.

Luceco LED IP65 Fire Rated GU10 Downlight, polished chrome finish, illuminated.

Слика 1: Luceco LED IP65 Fire Rated GU10 Downlight (Polished Chrome)

Ова слика приказује предњи део view of the Luceco LED IP65 Fire Rated GU10 Downlight. It features a polished chrome finish bezel with a central light source, designed for a sleek, modern appearance when installed in a ceiling.

2. Безбедносне информације

3. Садржај пакета

Пре него што наставите са инсталацијом, проверите да ли су све компоненте присутне и неоштећене.

4. Спецификације

БрандЛуцецо
Број моделаEFDGUIPPC-01
Димензије производа9.63 к 12.48 к 12 цм
Тежина280 грама
МатеријалМетал
ЗавршиПолирани хром
СтилеFixed Fire Rated GU10 Downlight / IP65 Rated
Lamp ХолдерГУ10
Мак Ватtage35W (сијалица није укључена)
ИП РатингIP65 (Suitable for bathrooms Zone 1 & 2)
Ceiling Cut-out Diameter72 мм (приближно)

5. Подешавање и инсталација

Важно: Installation should only be performed by a qualified electrician. Ensure power is disconnected before starting.

  1. Припремите плафон:

    Using an appropriate hole saw, cut a circular opening in the ceiling with a diameter of approximately 72mm. Ensure there is sufficient vertical clearance in the ceiling void for the downlight's housing (approx. 12cm depth).

  2. Ожичење:

    The downlight features tool-free access and loop-in loop-out terminals. Carefully strip the insulation from the live, neutral, and earth wires of your mains supply. Insert the wires into the corresponding push-fit terminals (Live, Neutral, Earth). Ensure a secure connection for all wires, especially the earth wire, due to the metal casing.

    Позади view of Luceco downlight showing wiring terminals and spring clips.

    Слика 2: Downlight Rear View са ожичењем

    This image displays the rear of the downlight, highlighting the black cylindrical housing, the spring-loaded clips for ceiling retention, and the push-fit wiring terminals for electrical connection.

  3. Insert GU10 Bulb:

    Before inserting the downlight into the ceiling, insert a GU10 bulb (not supplied) into the lamp holder. Align the two pins of the GU10 bulb with the slots in the lamp holder, push gently, and twist clockwise to secure it. Ensure the bulb length is within the 50-60mm limit.

  4. Install Downlight into Ceiling:

    Fold back the spring clips on the sides of the downlight housing. Carefully push the downlight into the prepared ceiling opening until the spring clips engage and hold the fitting securely in place. Ensure the rubber gasket is properly seated to maintain the IP65 rating.

  5. Attach Bezel:

    The polished chrome bezel is secured by a twist mechanism. Align the bezel with the main housing and twist clockwise until it clicks securely into place. Ensure it is flush with the ceiling surface.

    Polished chrome bezel for the downlight.

    Слика 3: Polished Chrome Bezel

    This image shows the separate polished chrome bezel, which is the visible trim of the downlight once installed. It features a smooth, reflective surface and a textured edge for grip during installation.

  6. Врати снагу:

    Once installation is complete and all connections are secure, restore power at the consumer unit/fuse box.

6. Упутство за употребу

The Luceco LED IP65 Fire Rated GU10 Downlight operates via your standard wall light switch. Simply toggle the switch to turn the light on or off.

7. Одржавање

КСНУМКС. Решавање проблема

ПроблемМогући узрокРешење
Светлост се не пали.
  • Нема струје у колу.
  • Неисправна сијалица.
  • Слаба веза ожичења.
  • Проверите прекидач/осигурач.
  • Replace GU10 bulb.
  • Switch off power and check wiring connections. Consult a qualified electrician if unsure.
Bezel does not sit flush.
  • Incorrectly aligned.
  • Опструкција.
  • Remove and re-align the bezel, twisting clockwise until secure.
  • Check for any debris or misaligned components.

9. Информације о рециклирању

This product falls under the Waste Electrical and Electronic Equipment (WEEE) directive. Do not dispose of electrical products with household waste. Please recycle where facilities exist. Check with your local authority for recycling advice.

For information on recycling light bulbs and how to clean up broken lamps, please refer to local guidelines or official recycling resources.

10. Гаранција и подршка

Luceco products are manufactured to high standards and are designed for durability. For specific warranty details or technical support, please refer to the warranty card included with your purchase or visit the official Luceco webсајт. Сачувајте доказ о куповини за потребе гаранције.

Повезани документи - EFDGUIPPC-01

Преview Luceco Водич за инсталацију противпожарне ЛЕД компактне фиксне уградне светиљке
Свеобухватно упутство за инсталацију и употребу Luceco компактне фиксне уградне светиљке са противпожарном ЛЕД заштитом. Укључује монтажу, ожичење, димензије, захтеве за изолацију и контакт информације.
Преview Luceco спољашња декоративна Е27 фењер за аутобусе са PIR сензором покрета - упутство за инсталацију и употребу
Свеобухватно упутство за инсталацију и употребу декоративне спољне аутобуске лампе Luceco E27, са PIR сензором покрета. Садржи листу додатне опреме, упутства корак по корак и информације о техничкој подршци.
Преview Упутство за инсталацију и употребу фотоћелије Luceco Storm LSPC500-01
Свеобухватно упутство за инсталацију и употребу фотоћелије Luceco Storm (LSPC500-01). Овај сензор светла за спољашњу употребу са заштитом IP65 је дизајниран за кућну употребу и има трогодишњу гаранцију. Садржи техничке спецификације, упутства за инсталацију корак по корак са описима дијаграма и контакт информације.
Преview LUCECO Соларни рефлектор са PIR сензором: Упутство за инсталацију и употребу
Свеобухватни водич за инсталирање и рад LUCECO соларног рефлектора Guardian са PIR сензором. Карактеристике укључују соларно напајање, детекцију покрета, IP65 заштиту и више режима рада.
Преview Упутство за инсталацију и употребу Luceco LED ECO Climate T8 IP65
Детаљна упутства за инсталацију и употребу антикорозивне светиљке Luceco LED ECO Climate T8 IP65, укључујући упутства за монтажу, ожичење и замену компоненти.
Преview Luceco LED ECO Climate T8 IP65 антикорозивна светиљка: Упутство за инсталацију и употребу
Детаљно упутство за инсталацију и употребу антикорозивне светиљке Luceco LED ECO Climate T8 IP65. Обухвата монтажу, ожичење, замену компоненти, гаранцију и безбедносне информације.