SPYPOINT FLEX Series Camera User Guide

SPYPOINT FLEX Series Camera

IN THE BOX

• FLEX SERIES
  • Camera
• ANTENNA & GASKET
• HARGING CABLE
  • FLEX-S & FLEX-S-DARK only
• SIM CARDS
  • Preactivated and inserted (do not remove)
• INSTALLATION
  • STRAP

REQUIRED (sold separately)

• MEMORY CARD
  • 2 to 512 GB class 10 ultra-high speed new microSD card
• 8 AA
  • Lithium non-rechargeable recommended (Optional for
  • FLEX-S & FLEX-S-DARK) – FLEX-PLUS 8 or 16 AA
• LIT-22
  • Rechargeable lithium battery pack (Optional for
  • FLEX-S & FLEX-S-DARK) – FLEX-PLUS 1x or 2x LIT-22

BEFORE YOU GO TO THE FIELD

Getting ready, first time use

flex-s & FLEX-S-DARK only

1. Charge the internal battery.
   • While the camera is off, plug the charging cable into the camera DC port. The status light will illuminate red while charging and turn off when fully charged. It is recommended to charge the battery fully (approximately 12 hours).
2. Create an account on spypoint.com/activate.
3. Download the SPYPOINT app and sign in.
4. In the Cameras tab, press the button.
   • Follow the instructions on the screen to add your camera.
5. Screw in antenna & insert memory card, batteries.
   • Insert the tray(s) following the arrow orientation.
6. Turn your camera ON.
   • All LEDs will begin to blink.
7. Format your memory card.
   • Immediately hold down the FORMAT button until the LED blinks green. Format is complete when LED stops blinking.
8. Press the TEST button to receive a photo.
9. Turn your camera OFF until you’re ready to install it in field.
   • IN THE FIELD
10. Flex-s & FLEX-S-DARK only
    • Install your camera in a location where the solar panel will receive at least 4 hours of direct sunlight.
    • Tips
      • Use: Installation strap
      • Orientation: North or South
      • Height: Subject’s mid-body
      • Lens sight: No leaves, branches or tall grass in front
11. Turn your camera ON & test it.
    • (Steps 6 & 8)

COMPONENTS

1. Microphone
2. IR LED
3. Light sensor
4. Delay light
5. Photo lens
6. Detection lens
7. Battery level
8. Signal level
9. STATUS light
10. FORMAT button
11. TEST button
12. OFF/ON switch
13. Antenna
14. Antenna gasket
15. Antenna O-Ring
16. DC jack
17. Cable lock hole
18. Locking latch
19. Slots for installation strap
20. Screw-thread for standard
    • ¼”-20 tripod mount
21. Battery door
22. microSD card slot
23. Micro SIM card slots
24. Battery tray
25. Solar panel

More information: Available in the certification guide.

FAQs

• Q: What should I do if my camera is not detecting motion?
  • A: Check the detection lens for any obstructions like leaves or tall grass. Ensure the camera is placed at the recommended height and orientation for optimal performance.
• Q: How do I know when the battery is low?
  • A: The battery level indicator on the camera will show you the remaining battery level. It is recommended to keep spare batteries on hand for uninterrupted operation.