SPARK MS-TA13F Delay On Time Relay
SAFETY PRECAUTIONS
- The device must be installed by a qualified person,
- Disconnect all power before working on the device. Don’t touch any terminal when the power is ON.
- Verify correct terminal connection when wiring.
- Don’t dismantle or repair the device whether it operates normally, otherwise, no responsibility is assumed by the producer and seller.
- Never use the device at the site which can be invaded by coTode gas, strong sunshine light and rain.
- Clean the device with a dry cloth.
- Fail to follow these instructions will result in serious injury or death.
FEATURES
- Microcontroller based
- Delay ON
- Repetition accuracy $0.2%
- LED indication for power supply and relay status
- 1 Modute Din-rait mounting
TECHNICAL DATA
| Supply terminals | A1,A2 |
| Supply voltage | AC/DC 24-240V |
| Rated frequency | 50/60Hz |
| T,me range | See timing range table |
| Setting accuracy | <5% |
| Repetition accuracy | s0.2% |
| Output contacts | 1 C/O |
| Current rating | 8A/AC1 |
| Contacts capacity | AC-15: 2A |
| Insulation voltage | 250V |
| Protection degree | IP20 |
| Pollution degree | 3 |
| ElectricaUife | 105 |
| Mechanical life | 106 |
| Altitude | s2000m |
| Ambient temperature | -5°C-+40°C |
| Storage temperature | -10°C-+50°C |
| Wire size | 0.5mm2-1mm2 |
| Torque | 0.5Nm |
| Mounting | TH-35 DIN-Rail |
APPEARANCE
DELAY ON TIME RELAY
Please read complete instructions prior to installation and operation of the device.
TIMING RANGE TABLE
FUNCTION DIAGRAMS
WIRING DIAGRAM
DIMENSIONS
Documents / Resources
 |
SPARK MS-TA13F Delay On Time Relay [pdf] Instruction Manual MS-TA13F, Delay On Time Relay, MS-TA13F Delay On Time Relay |
