Switch Man M5
Quick Guide V1.0

Switchman Smart Wall Switch

1. Power off

Please install and maintain the device with a professional electrician. To avoid electric shock hazards, do not operate any connection or contact the terminal connector while the device is powered on!

2. Wiring instruction

Light fixture wiring instructionMake sure all wires are connected correctly.

3. Download the eWelink Apphttp://app.coolkit.cc/dl.html

4. Power on

After powering on, the deavice will enter the bluetooth pairing mode during the first use. the Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.
LIKE IT!
Glad to know you are satisfied with SONOFF products. It would mean a lot to us if you can take a minute to share your buying experience.

https://www.youtube.com/channel/UC1EsS_wR0_isqSbbN-ZM8GAhttps://www.facebook.com/SONOFF.official/

HAVE A PROBLEM?
We are so sorry for the inconvenience caused by the product. Please contact us for help via the email address below.support@itead.cc
We will get back to you as soon as possible.The device will exit the Bluetooth Pairing Mode if not paired within 3mins. If you want to enter this mode, please long press any pairing button for about Ss until the Wi-Fi LED indicator changes in a cycle of two short and one long flash and release.

5.Add device

Tap “+” and select “Bluetooth Pairing”, then operate following the prompt on the Aoo.
User Manual

https://www.sonoff.tech/usermanuals
Scan the QR code or visit the website to learn about the detailed user manual and help.

FCC Warning

Changes or modifications not expressly approved by the party responsible for compliance could avoid the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
https://sonoff.tech/usermanuals

Shenzhen Sonoff Technologies Co., Ltd.
3F & 6F, Bldg A, No. 663, Bulong Rd, Shenzhen, Guangdong, China
ZIP code: 518000 Website: sonoff.tech
MADE IN CHINA

Documents / Resources

	SONOFF M5-120 Switchman Smart Wall Switch [pdf] User Guide M5-120 Switchman Smart Wall Switch, M5-120, Switchman Smart Wall Switch
	SONOFF M5-120 SwitchMan Smart Wall Switch [pdf] User Guide M5-120 SwitchMan Smart Wall Switch, M5-120, SwitchMan Smart Wall Switch, Smart Wall Switch, Wall Switch, Switch

References

• User Manual