Solinst 464 Mk3 Electronic Control Unit User Guide
Control Panel
Select a menu item. Press and hold to turn Control Unit off.
Navigate through menus and menu items.
Cycle through numbers and letters when editing.- Manual Control Valve: When pushed, solenoid opens, allowing drive cycle.
- Regulator: Turn to increase or decrease pumping pressure.
- Battery Enclosure: 4 AA alkaline batteries.
- Air Out: Drive line to pump.
Note: Always use the supplied Drive Line with quick exhaust fitting. - Air In: Supply line from compressed gas supply.
Notes:
- The Control Unit does not come with the batteries installed.
- Pressing any keypad button will turn the Control Unit on.
- A Timer indicates amount of time remaining before Unit turns off. Unit will automatically turn off after 5 minutes of being idle.
- B Battery life remaining. Icon will flash at 0% battery.
- C Percentage of battery life remaining.
- D Indicates a menu can be accessed using left cursor.
- E Indicates there is a sub-menu for the active menu item.
- F User Flow Rates: Create, Save, and edit customized drive/vent cycles.
- G LCD Contrast: Adjust contrast of LCD screen.
- H About: Displays installed firmware version.
Preset Flow Rates: Select a flow rate with predefined drive and vent cycles:PRESET FLOW RATES
Flow Drive Vent Low 50 s 25 s Med 10 s 8 s High 3 s 3 s 
For further information contact: Solinst Canada Ltd. 35 Todd Road, Georgetown, Ontario Canada L7G 4R8
Web Site: www.solinst.com
E-mail: instruments@solinst.com
Tel: 905-873-2255 or 800-661-2023
Fax: 905-873-1992 or 800-516-9081
Documents / Resources
 |
Solinst 464 Mk3 Electronic Control Unit [pdf] User Guide 464 Mk3, Electronic Control Unit, 464 Mk3 Electronic Control Unit |
