Water Level Data Loggers
Instructions
DataGrabber Firmware Upgrade Instructions
For use with Model 3001/3002/3250/3500
The DataGrabber 5 and DataGrabber (with a serial number greater than 325524) have been designed with firmware that is easy to update whenever useful new functions or other improvements become available.
Note: If updating a DataGrabber, it must have firmware version 2.000 or higher to allow a firmware upgrade. The original DataGrabber firmware version can be found on a label inside the battery compartment. Contact Solinst if you require a firmware upgrade and have a firmware version lower than 2.000.
To update the firmware in your DataGrabber, go to the Solinst Website at: https://downloads.solinst.com
Note: DataGrabber and Mk1 DataGrabber 5 units (sold before October 2022) can only be upgraded to Firmware version 3.002.
You can sign-in or register to gain access to the DataGrabber firmware upgrade file that is contained within a zip archive.
Make sure you unzip the archive to access the firmware *.ssf file
Firmware Update Instructions
- Press and hold the DataGrabber button for 2 seconds to power-on the DataGrabber. – If there is a flashing red light during startup, replace the 9V battery. – Wait for the light to flash fuchsia, then press and hold to turn the DataGrabber off.
- Save the firmware *.ssf file on a USB flash drive key.
- Plug the USB key into the DataGrabber.
- Power-on the DataGrabber.
- If a firmware file is found on the USB key, and the version is more recent than what is currently installed, the upgrade process will begin. A white light rapidly flashes as the process takes place.
Note: The original DataGrabber firmware version can be found on a label inside the battery compartment. - Once the firmware upgrade is complete, the normal self-test sequence is performed (see DataGrabber Operating Instructions for more information on the self-test and indicator light).
- If no firmware file is present on the USB key or the firmware file is old, the DataGrabber switches to the self-test and normal operation
Startup Status
Self Test
OK
Hashing = low battery
Flashing = Levelogger not connected
Flashing = USB not connected
Powering down
Data Transfer Status
Hashing = data transferring
Data transfer successful
Data transfer failed
Solinst Canada Ltd. 35 Todd Road, Georgetown,
Ontario Canada L7G 4R8 www.solinst.com
E-mail: instruments@solinst.com
Tel: +1 905-873-2255; 800-661-2023
Fax: +1 905-873-1992
September 29, 2022
Documents / Resources
 |
Solinst 3001 Water Level Data Loggers [pdf] Instructions 3001, 3002, 3250, Water Level Data Loggers, Level Data Loggers, Water Data Loggers, Data Loggers, Loggers |
