ZEBRA WS5001 Android Wearable Computer
Specifications
- Model: WS50/WR50
- Brand: Zebra
- RF Frequency: Class 2
- LED: Zebra ITE[SELV]
RF Frequency Usage
Ensure the device operates within the Class 2 RF frequency range. Maintain a minimum separation distance of 1 cm from the body to meet RF exposure requirements.
LED Usage
Refer to zebra.com/batterydocumentation for battery information. Use Zebra-approved accessories only.
Regulatory Compliance
Complies with Directive 2014/53/EU and 2011/65/EU for EEA. For US and Canada, complies with FCC Part 15 rules and ISED licence-exempt RSSs.
FAQs
Q: How do I ensure compliance with RF exposure requirements?
A: Maintain a minimum separation distance of 1 cm or more from the body and use only Zebra tested and approved accessories as specified in the user manual.
Q: Where can I find more information on regulatory compliance?
A: Visit zebra.com/doc for Declaration of Conformity (DoC) details and zebra.com/weee for EU Waste Electrical and Electronic Equipment (WEEE) information.
States and Canada Regulatory
Radio Frequency Interference Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
· Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements Canada
This device complies with Innovation, Science and Economic Development Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radio électrique subi même si le brouillage est susceptible d’en compromettre le fonctionnement.
This device is restricted to indoor use when operating in the 5150 to 5350 MHz frequency range.
Lorsqu’il fonctionne dans la plage de fréquences 5 150- 5350 MHz, cet appareil doit être utilisé exclusivement en extérieur.
This radio transmitter [109AN-WR50] has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list and having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.Le présent émetteur radio [109AN-WR50] a été approuvé par Innovation, Sciences et Développement économique Canada pour fonctionner avec les types d’antenne énumérés cidessous et ayant un gain admissible maximal. Les types d’antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué pour tout type figurant sur la liste, sont strictement interdits pour l’exploitation de l’émetteur.
Antenna ID: RFID03N-N0-01 Patch: 1.65 dBi, 50 ohms
6
RF Exposure Requirements – FCC and ISED
The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated in compliance with the FCC RF emission guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of fcc.gov/oet/ea/fccid.
To satisfy RF exposure requirements, this device must operate with a minimum separation distance of 1 cm or more from a user’s body and nearby persons.
Pour satisfaire aux exigences d’exposition aux radio fréquences, cet appareil doit fonctionner avec une distance de séparation minimale de 1 cm ou plus de corps d’une personne.
To satisfy RF exposure requirements, this device must be wrist-worn or body-worn either on a pocket, lapel, or belt using a clip-mount and where applicable use only with Zebra tested and approved accessories.
Pour satisfaire aux exigences d’exposition aux RF, cet appareil doit être porté au poignet ou sur le corps avec le clip de montage sur une poche ou une ceinture, et le cas échéant, utiliser uniquement avec des accessoires testés et approuvés par Zebra.
Cet appareil a été testé et déclaré conforme aux limites applicables d’exposition aux radiofréquences (RF).
Le débit d’absorption spécifique (DAS) local quantifie l’exposition de l’utilisateur aux ondes électromagnétiques de l’équipement concerné.
Les valeurs SAR les plus élevées sont disponibles sur la déclaration de conformité (DoC) disponible sur: zebra.com/doc
Note 1: “Exceeding 0.1 wt%” and “exceeding 0.01 wt%” indicate that the percentage content of the restricted substance exceeds the reference percentage value of presence condition. Note 2: “O” indicates that the percentage content of the restricted substance does not exceed the percentage of reference value of presence. Note 3: The ” – ” indicates that the restricted substance corresponds to the exemption.
Türkiye
TÜRK WEEE Uyumluluk Beyani
EEE Yönetmeliine Uygundur.
9
(Specific Absorption Rate SAR) · WS5001 0.14 w/kg
United Kingdom
Statement of Compliance
Zebra hereby declares that this radio equipment is in compliance with the Radio Equipment Regulations 2017 and the Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012. Any radio operation limitations within UK are identified in Appendix A of UK Declaration of Conformity. The full text of the UK Declaration of Conformity is available at: zebra.com/doc. UK Importer: Zebra Technologies Europe Limited Address: Dukes Meadow, Millboard Rd, Bourne End, Buckinghamshire, SL8 5XF
10
Zebra . zebra.com/warranty
.
. Zebra (zebra.com/support) .
zebra.com/support .
Zebra . Zebra zebra.com/support .
Support() > Products() Support() > Software Downloads( ) .
, entitlementservices@zebra.com Zebra .
·
·
·
·
Zebra , Zebra .
· zebra.com/ws50-info. . · supportcommunity.zebra.com/s/knowledge-base
. · supportcommunity.zebra.com . · zebra.com/support , , . · zebra.com/repair .
Zebra zebra.com/patents .
11
Documents / Resources
 |
ZEBRA WS5001 Android Wearable Computre [pdf] Instructions WS5001, WS5002, WS5001 Android Wearable Computre, WS5001, Android Wearable Computre, Wearable Computre, Computre |