ZALMAN T7 ATX Mid Tower Computer Case
Precautions
- Read this manual carefully before installing.
- Check the product and components before installing. If you find any abnormality, contact the location where you purchased the product for a replacement or refund.
- Wear gloves to prevent accidents when installing the product.
- Severe damage may occur when mounting the system, so do not apply excessive force.
- Connecting the cable incorrectly may cause a fire due to a short circuit. Make sure to refer to the manual when connecting the cable.
- Be careful not to block the ventilation hole of the product when using the system.
- Avoid locations with direct sunlight, water, moisture, oil, and excessive dust. Store and use the product in a well-ventilated location.
- Do not wipe the surface of the product using chemicals. (organic solvents such as alcohol or acetone)
- Do not insert your hand or other object into the product during operation, as this may injure your hand or damage the object.
- Store and use the product out of children’s reach.
- Our company assumes no responsibility for any problem that occurs due to the use of the product for purposes other than its designated purposes and/or the carelessness of the consumer.
- The exterior design and specifications of the product are subject to change without prior notice to consumers for quality improvement.
Specifications
| Model | T7 | |
| Case Form Factor | ATX Mid-Tower | |
| Dimensions | 384(D) x 202(W) x 438(H)mm | |
| Weight | 3.2kg | |
| Case Materials | Plastic, Steel, Acrylic | |
| Motherboard Support | ATX / mATX / Mini-ITX | |
| Maximum VGA Length | 305mm | |
| Maximum CPU Cooler Height | 160mm | |
| Maximum PSU Length | 150mm | |
| PCI Expansion Slots | 7 | |
| Drive Bays | 2 x Combo(3.5” or 2.5”), 4 x 2.5” | |
| Fan Support | Top | 2 x 120mm |
| Front | 3 x 120mm | |
| Rear | 1 x 120mm | |
| Bottom | 2 x 120mm | |
| Pre-Installed Fan(s) | Front | 1 x 120mm |
| Rear | 1 x 120mm | |
| I/O Ports | 1 x Headphone, 1 x Mic, 2 x USB 2.0, 1 x USB 3.0,
Reset Button, Power Button |
|
Dimensions
Accessories
I/O Ports
| # | Part | # | Part | # | Part | # | Part |
| ⓐ | HDD / Power LED | ⓑ | Reset Button | ⓒ | Microphone Jack | ⓓ | Headphone Jack |
| ⓔ | USB 2.0 Ports | ⓕ | USB 3.0 Port | ⓖ | Power Button |
Removing the side panels
- Tempered Glass
- Steel Panel
Removing the front panel
Mounting the motherboard
Motherboard size
- ATX
- mATX
- Mini-ITX
Mounting the PSU
Mounting the PCI-E(VGA) card
Mounting the 3.5″ and 2.5″ SSD / HDD
Mounting the 2.5″ SSD / HDD
Fans Included / Specifications
- RPM : 1100± 10%
- Input: 12V 0.24A
Mounting the fans
- Mounting the top fans
- Mounting the front fans
- Mounting the bottom fans
I/O Connectors
- To ensure safe and easy installation, please read the following precaution.
- Product design and specifications may be revised to improve quality and performance without notice.
- www.zalman.com
Documents / Resources
 |
ZALMAN T7 ATX Mid Tower Computer Case [pdf] User Manual T7, ATX Mid Tower Computer Case, T7 ATX Mid Tower Computer Case, Mid Tower Computer Case, Tower Computer Case, Case |
 |
ZALMAN T7 ATX Mid Tower Computer Case [pdf] User Manual T7 ATX Mid Tower Computer Case, T7, ATX Mid Tower Computer Case, Mid Tower Computer Case, Tower Computer Case, Computer Case, Case |
