QUICK INSTALLATION GUIDE
This document describes the basic steps required in order to start working with the XVC encoder and decoder.
The minimum settings required are the network parameters.
Once set, the unit will be accessible through the web browser.
For additional procedures and information please refer to the XVC Encoder user manual.
Step 1
Install the XVC management tool.
Follow the wizard instructions (Please download the configuration tool from www.xvtec.com/software-update/)
Step 2
Connect video sources to the unit (optional)
Step 3
Connect the Ethernet cable to the encoder
Step 4
Connect the power supply
Step 5
The power led turns on after approx. 3 secs. The unit boot time is approx. 30 secs, after which the unit will respond to commands.
Step 6
Run the management tool. The tools discovers and lists all XVC devices on the network.
Step 7
In order start working with the unit, the IP should be set to match your network configuration.
In the management tool, right-click a unit and select Set IP.
Set the IP parameters (STATIC/DHCP) and the rest of the network parameters based on your network settings. Press Apply
Step 8
In the management tool, double-click a unit in order to launch the web browser. A verification pop-up will appear. The defaults are:
a. User name admin
b. password admin
The main page of the XVC encoder/decoder will appear.
Step 9
To start streaming please refer to the user guide for the next steps. Download the user guide from:
https://xvtec.com/wp-content/downloads/XVC_HDMI/XVC_USER_GUIDE.pdf
Documents / Resources
 |
XVTEC XVC 4K Ultra Low Latency HDMI Encoder [pdf] Installation Guide XVC 4K Ultra Low Latency HDMI Encoder |
