Viotel V2.1 Wireless Accelerometer Node
Specifications
- Product Name: Viotel Wireless Accelerometer Node
- Sensor Type: Triaxial MEMS sensor
- Communication Interface: Digital
- Noise Level: Ultra-low noise
- Pre-programmed: Yes
- Mounting: Two-sided adhesive, side mounting holes, pole mount bracket
- Application: Monitoring vibration modes in buildings
Product Usage Instructions
Mount the device firmly to your chosen location using a secure mounting method such as two-sided adhesive, side mounting holes, or pole mount bracket for threaded holes.
- Place the magnet at the center of the ‘O’ in the Viotel logo.
- Count LED blinks for desired commands.
- 1 LED blink corresponds to 1 second.
- Release the magnet to end command input.
- 1 LED Blink: Solid blue light if the device is off; solid green followed by red light if on.
- 4 LED Blinks: Turn the device on/off. Ensure setup using the motel.
- Note: Battery consumption varies between continuous and triggered modes.
- Access your node’s Dashboard to view data.
FAQ
- What is Resonance?
- Resonance describes the phenomenon of increased amplitude that occurs when an external force or vibrating system matches a natural frequency.
- How can I contact support?
- For queries, email support@viotel.co
Quick Start Guide
ACCELERATOR METERNODE
MOUNT
- Mount the device firmly to your chosen location using a secure mounting method: Two-sided adhesive, side mounting holes and/or pole mount bracket for threaded holes.
USING THE MAGNET
Wherever instructed to hold the magnet in place, do so at the center of the ‘O’ in the Viotel logo.
- Count the number of LED blinks to the desired command.
- 1 LED blink corresponds to 1 second.
- Release the magnet from the hold position will end the command input.
CONFIRM STATUS
- 1 LED Blink
- If the device is off, a solid blue light will appear from the status LED. Proceed to step 4.
- If the device is on, a solid green light followed by a red light will appear from the status LED. Proceed to step 5.
TOGGLE DEVICE ON/OFF
- 4 LED Blinks
- This will turn the device on/off.
- Confirm the device is set up using myViotel.
- Note: battery consumption varies between continuous and triggered modes.
VIEW DATA
- Please head over to your node’s Dashboard to begin seeing the data.
Please refer to the User Manual for more information and a full guide on this device.
| STATUS | |
| GREEN | On |
| BLUE | Off |
| RED | Device is busy |
| PURPLE | Confirming Command |
| COMMS | |
| BLUE | Communicating with server |
| YELLOW | Collecting GPS Coordinates |
| RED | Unable to Communicate |
OUR RESONANCE
- Resonance describes the phenomenon of increased amplitude that occurs when an external force or a vibrating system is equal to or close to the natural frequency of the system on which it acts.
- Leveraging decades of experience in earthquake analysis and monitoring of mining seismicity, Viotel has a deep understanding of resonance and has developed a unique series of asset management solutions involving monitoring and analysis of vibrations and waveforms.
- The Virtual Wireless Accelerometer Node is an ultra-low noise triaxial MEMS sensor and self-contained with a digital communication interface.
- It comes pre-programmed and ready to mount in the desired location and is suitable for measuring the vibration modes in buildings.
CONTACT
Documents / Resources
 |
Viotel V2.1 Wireless Accelerometer Node [pdf] User Guide V2.1 Wireless Accelerometer Node, V2.1, Wireless Accelerometer Node, Accelerometer Node, Node |