NO-DIG FAUX
STONE EDGING KIT
EASY TO INSTALL
INST-VIG-FS-RV0 No Dig Faux Stone Edging Kit
Always use proper safety precautions when cutting and spiking edging.
Protective eyewear and gloves are recommended during installation.
Clear the installation area of grass, loose soil, and debris. Slide edging pieces together so anchoring tabs overlap. 
Hammer anchoring spikes (included) on each end of the installation and at connection points to secure edging.
Backfiill with mulch, river rock, or other ground cover.
Assure tabs are completely covered with a thick layer of bedding material.
CONNECTION SYSTEM
An overlapping post system stabilizes joints without additional connector pieces to create seamless borders. 
HELPFUL TIPS & INFORMATION
Installation:
Enough anchoring spikes are included to accommodate typical installations. Certain conditions and landscape designs can require additional spikes, which are available in stores and online.
Anchoring spikes should be driven only to the top of the edging tab. Pounding the spike to the point the tab bends can damage the edging.
Generously cover tabs with soil and groundcover.
Heavy bedding materials such as rock and mulch tend to perform best.
Preparation:
Soil must be solid and level. Assure there is no debris between the edging tab and the dirt below.
Compact the cleared soil prior to installation to reduce spike movement from shifting ground and frost heave.
Weed fabric can minimize the spread of invasive weeds and grass. Install fabric according to product directions, then place the landscape edging over the fabric and drive spikes through the tabs and fabric.
Questions/Comments? Contact us at
customersupport@dimexcorp.com
INST-VIG-FS-RV0
Documents / Resources
 |
Vigoro INST-VIG-FS-RV0 No Dig Faux Stone Edging Kit [pdf] Installation Guide INST-VIG-FS-RV0 No Dig Faux Stone Edging Kit, INST-VIG-FS-RV0, No Dig Faux Stone Edging Kit, Faux Stone Edging Kit, Stone Edging Kit, Edging Kit, Kit |