VAXEE NP-01S v2 wireless
User Guide
Contents of Package
- Mouse
- 4K Wireless Dongle
- Charging and Data Cable
Setup
Wired Mode
Connect the minuse to any USB porten your PC using the chararng cable
Wireless Mode
Connect the 4k dongle (VXD02] through the cable to the computer.
Mouse Features
- Left Buttan
- Right Butten
- Mickie Button
- Back Buttori
- Forwvatel Buttan
- Botton Button
- Power Swiech
Specifications
DPA Gethings: 400/800 1606/3200 dos
Acijustable USE Report Ramee SOG / 1800 / 2006 /4000 Ha
Actiusraiae Clix Latency: O10) / 2M) / 4060 me
Adjjustatie Competitive Mock: On {Cit
scuatable Motion Syne. On / OF
Sapteary Lids Stencnarcd fee 110 rours / Compeeniep C38 tens {9K 34 hours /4t0 $0 hours
Charging Speed: From 096-000 in roughy Ine SOmire.
Waegnht S659
Seracr PAWTESO
Connector: V88
Suttons: 7 nuttons
Catia Lanottr.2 rranars (6 teat!
Recommended Usage Environment
For optimal wireless performance, use mouse within 20cm of Wireless Dongle and further than 2m from sources of 24GHz interference (such as Wi-Fi routers)
Charging and Power LED Lights
LED Lights during Charging
Hold the Right Button (2)+ Nide Button (3)to splay e currnt charge v oftho mouss.
Report Rate Adjustment
Hold the bottom button for 2 seconds, and the indicator will flash in cycles between DPYReport RataXcick Latency modes.
(Cycles through DPYReport Rate/Click Lavency)
Afver selecting ReportRate made (retease the bottorn buttan when switch to ReportRate mode}, the indicator light changes frarn flashing to steady Pressing the futon again at this point will cycle through the settings in the order of “4000Hz -> 2000Hz -> 1O0DHz -> SOOH2″.
DPI Adjustment
Hold the bottom button for 2 seconds, and the indicator wil flash in cycles between DPi/Report Rate/Click Latency modes.
(Cycles through DPV/Report Rata/Click Latency)
After selecting DPI mode {release the bottem button when switch to OPI mode}, the indicator light changes from flashing to steady. Pressing the button again at this point will cycle through the settings in the order of “Red -> Purple -> Blue => Green’.
Click Latency Adjustment
Hold the bottoms button far 2 sacands, and the indicator will flash in cyctas between DPI/Report Rate/Click Latency modes.
(Cycles through DPi/Repart Rate/Click Latency)
Aker selecting Click Latency mode (release the bottern pLtton when switch to Click Latency model, the incicater light changes from flashing to steady.
Pressing the button again at this point will cycie Uwough the settings in the order of “4ms (H} -» Zs (MJ -> Oms (L)”.
Competitive Mode Adjustment
Lift-off distance Adjustment
Motion Sync Adjustment
Displaying Mouse Status
Regulatory
FCC Approvet 
Thes chowce hed been besled in accordance veri ive procedines and in conpiance with Payt 16 Subpewi 6 of FAC Rafies, df] Kebpel of pepe accord bo ANSI 03 + & FC Pe 15 Peele aed CISPR? Clase B.
Fcc 15.21:
Any changes or modifications not eapresaty approved by the perty reapensible for compliance could void the user’s authority to operate the equipment.
15.19
This device compiies with part 16 of the FCC Rules. Operation is subject to the following two conditions: (Q This device may not cause harmful interference, and (2) this device must accept any interference received, nchuding interference that may cause undesired operation.
15.105:
This equipment has been tested ard found to cornply with the limits for a Class 8 digital device, pursvant to part 6 of the FOC Rules.
These limits ere designed to provide reasonable protection against harméul interference in 8 residential installation.
‘This equipment generates, uses and can radiate racic frequency energy and, li not installed and used in accordance with the inetructians, May cause harmié interference to radio communications. However, there is no guarantee that intesference will not occur in a particulars instaliztion. if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following meesures:
- Reorient or relocate the receiving artenna.
- Inerease the seperation between the equipment and receiver.
- Connect the equipment into an outiet on a cirout different trom thet to which the recetver Is connected.
- Consult the dealer or an expertenced radie/TV technician for help.
RF Exposure Warning: This device contains transmitters and receivers which emi Radio Frequency (RF) enorgy.
‘The device ia designed to comply wilh the limits for exposure to RF energy tet by the Federal Comsmenications Commissiqn (FCC) of the United States, industry Canada 0C) of Canada, and the reguistag entities of other countries.
Documents / Resources
 |
VAXEE NP-01S v2 Wireless Mouse [pdf] User Guide 2A9L8-NPS2WL, 2A9L8NPS2WL, nps2wl, NP-01S v2 Wireless Mouse, NP-01S v2, Wireless Mouse, Mouse |