T NICER-logo

T NICER G1EX Helmet Bluetooth Intercom

T NICER-G1EX-Helmet-Bluetooth-Intercom-product

Product Information

Specifications

  • Compliance: Part 15 of the FCC Rules
  • RF Exposure: Meets general RF exposure requirements
  • Usage: Portable exposure condition without restriction

Product Usage Instructions

FCC Warning

This device complies with Part 15 of the FCC Rules. Please ensure compliance with the following conditions:

  1. This device may not cause harmful interference.
  2. This device must accept any interference received, including interference that may cause undesired operation.

Note Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

RF Exposure

The device has been evaluated to meet general RF exposure requirements. It can be used in portable exposure conditions without restriction.

Frequently Asked Questions

  • Q: Can the device be used in areas with high interference?
    • A: The device is designed to accept interference, including in areas with high interference, as long as it does not cause harmful operation.
  • Q: Are there any restrictions on portable usage?
    • A: The device can be used in portable exposure conditions without restrictions.

Welcome to TNICER

  • Thank you for choosing TNICER Bluetooth communication system, by purchasing our products, you will get the most intimate protection and the most worry-free after-sales service.
  • All the products we bring to you are manufactured to the highest standards of performance and safety.
  • Adhering to the brand concept of “make cycling more free” we provide safer, smarter, and more convenient outdoor communication products for every cyclist” as our mission.

Product Functions Introduction

  • Qualcomm Bluetooth voice chip version 5.2
  • Intelligent DSP audio processing, CVC 12th generation noise reduction processing, 16K voice bandwidth transmission rate
  • 6 riders 1000 meters Bluetooth intercom communicate
  • One-click auto-connection
  • Music sharing
  • Voice assistant
  • Automatic answer, support last number redial
  • Intelligent microphone pickup
  • Support voice communication at 1 00km/h speed
  • 40mm tuned speaker diaphragm
  • I P65 waterproof
  • Support pairing with most third-party Bluetooth intercom

List of Packing Parts

T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-1

  1. G1 EX Unit
  2. Speaker & boom microphone
  3. Wired microphone
  4. Mounting bracket
  5. 3M double-sided pad
  6. 3M single-sided pad
  7. Speaker velcro
  8. Pads for thickening speakers
  9. Microphone velcro
  10. Metal clip
  11. Charging cable
  12. Manual

Two Ways of Installation

a) Use Double-sided Tape

  1. Wipe the surface of the helmet where the device will be mounted with the alcohol prep pad.
  2. Peel off the sticker of the double-sided pad and stick it on the mounting bracket.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-2
  3. Attach the mounting bracket with a double-sided pad to the helmet.
  4. Push the device toward the bottom of the helmet and snap it into the mounting bracket, the installation is complete.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-3

b) Use Metal Clip

  1. Peel off the sticker of the single-sided pad and stick it on the mounting bracket.
  2. Snap the metal clip into the mounting bracket.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-4
  3. Snap the mounting bracket with the metal clip in place into the bottom of the helmet.
  4. Push the device toward the bottom of the helmet and snap it into the mounting bracket, the installation is completeT NICER-G1EX-Helmet-Bluetooth-Intercom-fig-5

Function Keys Introduction

T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-6

Bluetooth Functions Operating Introduction

  1. Bluetooth Basic Functions OperationT NICER-G1EX-Helmet-Bluetooth-Intercom-fig-7
  2. Bluetooth Pairing with Different Devices
    • Note: Make sure the G1 EX is powered on and within 1 meter of the Bluetooth device you are about to pair with.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-8
  3. Phone Calls FunctionT NICER-G1EX-Helmet-Bluetooth-Intercom-fig-9
  4. Music Function
    • Note: Before using the music function, please make sure that G1 EX has been successfully connected to the Bluetooth of your cell phone.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-10
  5. Intercom Pairing and Using MethodsT NICER-G1EX-Helmet-Bluetooth-Intercom-fig-11

Note:

  1. The G1 EX can only pair with a maximum of one third-party intercom device.
  2. If there is an incoming call during an intercom call, the device will disconnect the intercom call automatically, and resume the intercom state after hanging up the phone call.
  3. During the intercom call, when the intercom with other devices is disconnected due to factors such as distance or environment, you can short press the [intercom button] once to return to the intercom state.
  4. When the device is in the intercom mode, short press the [intercom button] to disconnect the intercom, and press again to go back to intercom mode. Rotate the [multifunction button] to turn up/down the call volume.
  5. Intercom quality will be affected by environmental factors, it is recommended that the group intercom within 1000 meters, or too long a distance will increase the interference factors to affect the call experience.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-12

Music Sharing

Turn on music sharing:

  • When both devices are turned on, music must be shared from the party initiating the intercom to the other party.
  • For example, you can specify that music be shared from Device A to Device B. The procedure is as follows.
  1. Step 1: Ensure that devices A and B retain only each other’s pairing information (you can clear all pairing history for both devices)
  2. Step 2: Connect A to your phone’s Bluetooth (make sure Bisis  not connected to the same phone as A)
  3. Step 3: Open the Music app on your phone and put the song on pause.
  4. Step 4: Pairing the devices A and B. (Refer to the steps on the previous page to complete the pairing).
  5. Step 5: Short press the [Intercom Button] of A once to pause the intercom.
  6. Step 6: Long press A’s [intercom button + next button] for 2 seconds, then short press A’s [multifunction button] to start music playback. The music sharing is successful.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-13

Turn off music sharing:

Long press [intercom button + next button] on device A for 2 seconds to turn off music sharing.

Note:

  1. When device A shares music with B, A must be connected to the Bluetooth of the cell phone.
  2. The prerequisite for sharing music between A and B is that A and Bare are successfully paired.
  3. Under the music sharing status, device A can pause/start sharing by short pressing [multifunction button].T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-14

Product Charging Precautions

  1. Please fully charge the device before using it.
  2. Please use the charging head with SV1 A power or less with the charging cable.
  3. Don’t put the product in too high or too low-temperature environment, the best use environment is Oto 40 degrees, otherwise, it will shorten the product’s life.
  4. Keep away from the fire source.
  5. Keep away from sharp objects, otherwise, the product may be scratched or damaged.
  6. Do not disassemble the device.
  7. When not in use for a long time, please place the device in a dry environment and make sure to charge it once a month to ensure its performance.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-15

FCC Warning

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference,
  2. this device must accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, according to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

NOTE: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

  • More detailed installation and operation videos can be viewed on the official YouTube channel.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-16
  • YouTube Channel: TNICER
  • After-sale service email: tnicerservice@tognicer.com.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-17
  • If you have any questions, please feel free to contact us via after-sales service email.T NICER-G1EX-Helmet-Bluetooth-Intercom-fig-18

Documents / Resources

T NICER G1EX Helmet Bluetooth Intercom [pdf] Instruction Manual
2BHA4-G1EX, 2BHA4G1EX, G1EX Helmet Bluetooth Intercom, G1EX, Helmet Bluetooth Intercom, Bluetooth Intercom, Intercom

References

Leave a comment

Your email address will not be published. Required fields are marked *