STUDER RCC 02 Remote Control User Guide
Introduction
Congratulations!
You are about to install and use a high-end equipment that will play a central role in the energy management of your battery-based system. The bsp is a battery status processor for advanced monitoring of lead-acid batteries within an xtender system. This device has been designed, manufactured, assembled and tested in our factory in Switzerland. It has a 5-year warranty
General Information
Exclusion of liability
Studer disclaims all responsibility and liability for damage, costs or losses resulting from an installation that does not comply with the instructions, a faulty operation or inadequate maintenance. The use of studer equipment is in any case under the responsibility of the customer.
Read carefully the safety and operation instructions
Installation must be entrusted to qualified personnel
Check the user manual online
Need help?
Compatible with:
- Battery inverter/charger
xtender - Solar charge controller
vario - Advanced battery processor (lead-acid)
bsp - Communication with lithium BMS
xcom CAN - Remote monitoring (Portal & App)
xcom LAN/GSM - Communication bridges (openstuder)
xcom 232i/CAN/485i
Mounting and installation
Storage and content
Mounting place
The batteries should only be installed by qualified personnel.
Fixing and dimensions
rcc 02
Fixing and dimensions
rcc 03
Wiring
The device must be installed in accordance with local standards and regulations in force.
Multi units and power up
Up to 3 remote controls (rcc or xcom) per system
Display
Display system
Configuring the rcc
rcc 02/03
Configurating parameters
Language
Time
Date
User level (Info only – 460081, Basic – 943274, Expert – 426468)
Datalogger
Save and restore files
Backlight
Extended and special functions
Technical data
Protection Class I
Datalogging: SD card, 1 minute resolution
Save and restore: Configuration and logfiles backup
Communication cable: 2m (included)
Operating temperature range: -20 … 55°C
Maintenance and recycling
Except for the periodic check of the connections (tightening, general condition), the rcc does not require any particular maintenance. To dispose of this product, please use the service for the collection of electrical waste and observe all obligations in force in the place of purchase.
- Serial Number:
- Installed by :
- Date :
- Signature :
Call our specialists +41 27 205 60 80
or visit studer-innotec.com/support
Studer Innotec SA
rue des Casernes 57
1950 Sion, Switzerland
info@studer-innotec.com
© All rights reserved
Studer Innnotec SA – V1.0
Documents / Resources
 |
STUDER RCC 02 Remote Control [pdf] User Guide RCC 02 Remote Control, RCC 02, Remote Control, Control |
