smonet 13000 Power Core Smart Lock User Guide
1) Measure Door Width
If the door is thinner than 1½” or thicker than 1 1/4”, then the lock will not fit properly on the door.
2) Measure for Backset
If existing backset is not 2³⁄₈” or 2³⁄₄”, then the lock will not fit properly on the door.
3) Measure Hole Sizes
If hole sizes are larger than those shown, then the lock will not fit properly on the door.
If hole sizes are smaller than those shown, see steps 4 and 5.
If hole sizes are smaller than those shown, see steps 4 and 5.
4) If Needed, Enlarge Hole in Door
If hole in door is smaller than 2¹⁄₈”, then use 2¹⁄₈” hole saw to enlarge hole.
5) If Needed, Enlarge Hole in Door Edge
If hole in door edge is smaller than 1”, then use 1” drill bit to enlarge hole.
6) Check Strike (Door Jamb) Preparation
a. Place new strike box and strike against door jamb.
b. If strike box and strike do not fit properly, use pencil to trace around strike box and strike and mark hole positions.
c. If needed, use chisel and drill to correct door jamb preparation.
b. If strike box and strike do not fit properly, use pencil to trace around strike box and strike and mark hole positions.
c. If needed, use chisel and drill to correct door jamb preparation.
Contents
hide
Documents / Resources
 |
smonet 13000 Power Core Smart Lock [pdf] User Guide 13000 Power Core Smart Lock, 13000, Power Core Smart Lock, Core Smart Lock, Smart Lock, Lock |