G01 Remote Controller
Product Specifications
- Product: Floor Lamp
- Compliance: Part 15 of FCC Rules
- Conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including
interference that may cause undesired operation.
Product Usage Instructions
Installation
- Unbox the floor lamp and remove all packaging materials.
- Assemble the different parts of the lamp as per the included
instructions. - Place the lamp in the desired location, ensuring it is stable
and on a flat surface.
Operation
- Connect the floor lamp to a power source using the provided
power cord. - Use the switch or control panel on the lamp to turn it on and
adjust the brightness as needed. - Position the lamp head to direct the light where it is
required.
Maintenance
- Regularly dust the lamp with a soft, dry cloth to keep it
clean. - Check and tighten any loose screws or connections periodically
to maintain stability. - Replace any faulty bulbs with compatible ones to ensure proper
functionality.
Frequently Asked Questions (FAQ)
Q: Can I use LED bulbs with this floor lamp?
A: Yes, you can use LED bulbs as long as they are compatible
with the lamp’s specifications.
Q: Is it safe to leave the floor lamp on overnight?
A: It is recommended to turn off the lamp when not in use for
safety and energy-saving purposes.
Floor lamp
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. FCC Radiation Exposure statement The device has been evaluatec to meel general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Documents / Resources
 |
Shenzhen G01 Remote Controller [pdf] User Manual 2BPNL-G01, 2BPNLG01, G01 Remote Controller, G01, Remote Controller, Controller |