Check and Pull Double Sided Tape
Product Information
Specifications
- Product Name: Adhesive Strip Device
- Material: Plastic
- Color: Transparent
- Dimensions: 5 inches x 1 inch x 0.1 inch
Product Usage Instructions
Check and Remove the Protective Film
Before installation, ensure to check and remove the protective
film on both sides of the adhesive strip. This will expose the
adhesive surface for proper attachment.
Installation
1. Identify the front and rear of the adhesive strip device.
2. Peel off the protective film from the adhesive side.
3. Position the adhesive strip on the desired surface and press
firmly to ensure proper adhesion.
Removal
If you need to remove the adhesive strip device, follow these
steps:
1. Use a flat tool to gently lift one corner of the strip.
2. Slowly peel off the strip while applying constant pressure to
avoid damage to the surface.
3. Clean any residual adhesive with an appropriate solvent if
necessary.
FAQ
Q: What should I do if the adhesive loses its stickiness?
A: If the adhesive strip loses its stickiness, you can use an
additional adhesive strip to reattach the device.
Check and Remove the Protective Film
Adhesive Strip
Protective Film
Front
Installation
Rear
Check and Pull on the Double-sided tape
Otherwise, damage may occur to the device.
Removal
Use additional adhesive strip
1
2
3
4
Documents / Resources
 |
Scotch Check and Pull Double Sided Tape [pdf] Instruction Manual Check and Pull Double Sided Tape, Pull Double Sided Tape, Double Sided Tape, Sided Tape |