SATECHI Stand and Hub for Mac Mini Studio
USER MANUAL
IMPORTANT
- The USB ports are not designed for charging, only for device syncing, data transfer and USB peripherals.
- Upon initial installation, please ensure your SSD is properly formatted to your host device 0S.
- iPad will only sync via USB-A due to its power wattage requirement for syncing.
- When connecting headphones to audio port, please make sure to adjust sound output under System Settings >Sound > Output > USB PnP Audio Device.
FUNCTIONS
1. Built-in USB-C Connector
2. SD & Micro SD Card Slots (UHS-l Speeds)
3. Audio Jack Port
4.2X USB-A 3.2 Gen 1 Ports (5 Gbps)
5. USB-A 3.2 Gen 2 Port (10 Gbps)
6. USB-C 3.2 Gen 2 Port (10 Gbps)
7. LED Indicator
8. M.2 NVMe & SATA SSD Enclosure
SSD INSTALLATION
NOTE:
COMPATIBLE WITH M.2 NVME AND SATA SSD DRIVE +
PLUG & PLAY
1. Connect to your Mac Mini
2. Connect your devices
FCC
This device complies with part 15 of the FCC results. Operation is subject to the following two conditions:
1. This device may not cause harmful interference and 2. This device must accept any interference received, including interference that may cause undesired operation.
Note: This Equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the manufacturer could void the user’s authority operate the equipment.
CE DECLARATION OF CONFORMITY
Satechi declares that this product is in compliance with the essential requirements and other relevant provisions of applicable EC directives. For Europe, a copy of the Declaration of Conformity for this product may be obtained by visiting https://satechi.net/support/doc
WEEE Information
–
According to the WEEE (Waste Electrical and Electronic Equipment) Directive, do not dispose of this product as household waste or commercial waste. Waste electrical and electronic equipment should be appropriately collected and recycled as required by practices established for your country. For information on recycling of this product. please contact your local authorities, your household waste disposal service, or the shop where you purchased the product.
CAN ICES-003 (B)/NMB-003(8)
This Class B digital apparatus complies with Canadian ICES-003.
(Cet appareil numerique de la Classe B conforme a la norme NMB-003 du Canada)
NEED HELP?
Manufacturer:
7365 Mission Gorge Rd. Ste. G San Diego, CA 92120, USA
+1 858 268 1800
support@satech i. com
Documents / Resources
 |
SATECHI Stand and Hub for Mac Mini Studio [pdf] User Manual Stand and Hub for Mac Mini Studio, for Mac Mini Studio, Mac Mini Studio, Mini Studio, Studio |
