Remote Pro JJ-JS-SM18-B2DEA Remote Control Receiver

PRODUCT INFORMATION

Specifications

• Model: JJ-JS-SM18-B2DEA
• Power Input Selector: AC/DC 12V-24V
• Channel: 2CHS
• Frequency Range: 300MHz-868.8MHz
• Memory Capacity: 200pcs

Product Usage Instructions

Brand Selection

Use the 8-bit dip switch to select different combinations for various remote brands. Refer to the table for brand selection.

Learn Button and LED

The RX Multi receiver has 2 independent channels, each with its own learn button (SW1, SW2) and LED (L1, L2).

Operation

1. Select the correct brand for the remote using the dip switch.
2. Press the learn button. The LED will turn on.
3. Press a button on the remote. The LED will flash 4 times, indicating successful entry of that button into the RX Multi.
4. Repeat the above steps for additional buttons. Both channels work simultaneously.

Erase All Remote Data

• To erase all data in the memory card, press and hold either the learn button until the LED starts flashing.
• Continue holding the button until the LED turns off, indicating that all data has been permanently erased.
• Notice: Be cautious when erasing all data, as it cannot be recovered.

RX Multi

Technical Parameters

• Power Input Selector: AC/DC12V-24V.
• The user can choose the voltage by jumping the pin.
• Channel: 2CHS ；
• Frequency: 300MHz-868.8MHz；
• Memory Capacity: 200pcs；

Brand Select

• With 8 8-bit dip switches, the user can make different combinations for different remote brands. The brand’s selection is shown as a table.

Learn button and LED

In the RX Multi receiver, there are 2 independent channels. Each channel has an independent learn button, SW1, SW2 and LED L1, L2.

Operation

How to enter remote and erase all remotes.

Entry one button or remote:

1.  First, selecting the correct brands for remote will be entered by the dip switch.
2. Press the learn button, the LED turn on. Press the button on the remote, the LED flashes 4 times; this button entry into the RX Multi is successful.
3. Repeat step 2 for another button.
4. 2 channels work at the same.

Erase all data in the memory card:

• Pressing and holding either learn button, the LED starts flashing. Keep pressing this button until the LED turns off. All data in the memory card will be erased permanently.
• Notice: Be careful not to erase all data in the memory card. The data will be erased permanently and can not be recovered.

Table

Note: remote control with“★” is still testing.

FAQ

Can I recover data after erasing all remote data?

No, all data erased from the memory card is permanent and cannot be recovered.

Documents / Resources

Remote Pro JJ-JS-SM18-B2DEA Remote Control Receiver [pdf] User Guide JJ-JS-SM18-B2DEA, JJ-JS-SM18-B2DEA Remote Control Receiver, JJ-JS-SM18-B2DEA, Remote Control Receiver, Control Receiver, Receiver

References

• User Manual