REAMP Power Consumption Logger Software
Specifications:
- Product Name: Power Consumption Logger REAMP
- Power Source: 1.8V to 5V DC
- Current Consumption Monitoring Range: Instantaneous values
- Voltage Measurement Range: 20mV to 5V
- Input Channels: Two
- Interface: USB2
Product Usage Instructions
- Install the REAMP Logger software on your computer.
- Connect REAMP to the computer’s USB2 port.
- Insert the plastic 6-pin female connector module into REAMP’s front panel 6-pin male connector.
- Start the REAMP Logger software.
- Set the necessary output voltage in mV, power output (permanent or delayed), and other parameters.
- Connect the Device Under Test (DUT) to the power terminals ofthe plastic 6-pin connector: Pin 1 (+) and Pin 6 (- or Ground) directly or through special color-coded clips.
- Push the button to start measuring.
- The color graph on the right displays real-time power consumption characteristics during the measuring interval.
- To remove power from the tested device, set the Power output config to OFF.
- REAMP is a highly stable and accurate laboratory power source for different electronic devices powered by 1.8V to 5V DC.
- REAMP can monitor and measure instantaneous values of the current consumption, record them in a log file, and make other measurements.
- REAMP user manual lists all these possibilities.
- The range of current measurements is 10µA to 1A (100dB).
- Additionally, two input channels measure the voltage at any schematicpoint of the tested device. The range of these voltage measurements is20mV to 5V.
Working with REAMP.
- Install the REAMP Logger software
- Connect REAMP to the computer’s USB2 port.
- Insert the plastic 6-pin female connector module into REAMP’s front panel 6-pin male connector.
- Start the REAMP Logger software.
- Set the necessary output voltage in mV, power output (permanent or delayed), and other parameters.
- Connect the tested device (DUT) to the power terminals of the plastic 6 pin connector:
- Pin 1 – (+) and Pin6 (- or Ground) directly or through special color-coded clips.
- There are six clips of different colors if needed.
- Push the
button to start measuring. - The color graph on the right shows the real-time power consumption characteristics during the measuring interval. Setting the “Power output config” to OFF removes the power from the tested device.
RigExpert REAMP could be a handy tool for any electronic laboratory.FAQ
Q: What is the voltage measurement range of REAMP?
A: The voltage measurement range of REAMP is 20mV to 5V.
Q: How many input channels does REAMP have?
A: REAMP has two input channels for monitoring the voltage at different schematic points of the device.
Q: How can I achieve maximum battery life using REAMP?
A: By accurately monitoring and measuring the current consumption of your electronic devices with REAMP, you can optimize power usage and extend battery life.
Documents / Resources
 |
REAMP Power Consumption Logger Software [pdf] Owner's Manual Power Consumption Logger Software, Consumption Logger Software, Logger Software, Software |