RC FACTORY FLASH CL 39 Inch EPP Flash Control Line Plane
Specifications
- Model: FLASH CL
- Wingspan: 870 mm
- Length: 865 mm
- Weight: 250g
- Battery: Li-pol 3s 850mAh
- Motor: 2212 1000kv
- Propeller: 9×4.6
Product Usage Instructions
Assembly
- Follow the recommended measurements for cutting the required parts.
- Assemble the components using medium CA adhesive.
- Ensure proper balance by adjusting the CG between 25-35mm.
Flight Preparation
- Charge the Li-pol battery fully before the flight.
- Check all control surfaces for proper movement and secure connections.
- Perform a pre-flight check to ensure all components are functioning correctly.
Flight
- Launch the FLASH CL by hand or using a suitable launching device.
- Maintain control line movements to maneuver the aircraft.
- Monitor battery levels and land the aircraft safely before departure.
- 40mm … 2x (2pcs)
- 80mm … 1x (1pcs)
- 100mm … 2x (2pcs)
- 125mm … 1x (1pcs)
- 485mm
Dimension
USING INSTRUCTION
We wish you many happy flying hours with your Flash CL
RC Factory team
FAQ
- Q: What should I do if the motor is not starting?
- A: Check the battery connection and ensure the motor wires are properly connected. If the issue persists, consult with technical support.
- Q: How can I improve the aerobatic performance of the FLASH CL?
- A: Experiment with different propeller sizes and adjust the CG within the recommended range to enhance maneuverability.
Documents / Resources
 |
RC FACTORY FLASH CL 39 Inch EPP Flash Control Line Plane [pdf] Instruction Manual FLASH CL, FLASH CL 39 Inch EPP Flash Control Line Plane, 39 Inch EPP Flash Control Line Plane, EPP Flash Control Line Plane, Control Line Plane, Line Plane, Plane |
