W15110710015 Vector Controller
Instruction Manual
W15110710015 Vector Controller
VECTOR CONTROLLER REPLACEMENT PROCEDURES
PART # W15110710015
Required Tools: (Not included)
A. Phillips screwdriver
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
| Step 1 Using a Phillips screwdriver, remove two (2) screws from the battery cover on the right side of the unit. |
Step 2 Locate and disconnect the battery and charger port connectors from the controller. |
 |
 |
| Step 3 Continue to disconnect the rest of the connectors from the controller. |
Step 4 Using a Phillips screwdriver, remove one (1) screw located at the front of the controller and remove the controller. |
 |
 |
| Step 5 Reverse the steps. ATTENTION: Charge battery 8 hours before using. |
|
Need Help?
Visit our website at www.razor.com
or call toll-free at 866-467-2967
Monday – Friday 8:00am – 5:00pm Pacific Time.
Documents / Resources
 |
Razor W15110710015 Vector Controller [pdf] Instruction Manual W15110710015 Vector Controller, W15110710015, Vector Controller, Controller |
