R DE WIRELESS GO ii Microphone
USING INSTRUCTION
- Remove both transmitters from the charging case, remove the stickers covering their charging pins, and then return them to the case.
- Remove both transmitters from the case again – their LEDs will begin to flash, indicating they are now powered on.
- Remove the receiver from the case and connect it directly to your phone – its LEDs will flash to indicate it is pairing, and then remain solid when paired.
- Start recording!
- Download RØDE Central to adjust settings and update your firmware
- View the user guide to learn more about your Wireless Micro
IMPORTANT SAFETY INFORMATION
- Read and understand the instructions and safety guide completely before using the product.
- Ensure both the instruction manual and regulatory and safety guide are accessible to all users, including when passing the product on to third parties.
- Only use this product with authorized RØDE accessories.
- Do not open the product housing. This will void the warranty.
- Refer all service and repairs to RØDEapproved service personnel. Service or repair is required for products that have been damaged, exposed to liquid, rain, or moisture, or do not operate normally.
- Use the product only in the ways described in the instructions.
- Do not use the product if it was damaged during transportation.
- Keep the product away from liquids and electrically conductive objects that are not necessary for the operation.
- Do not use any solvents or corrosive cleaning agents to clean the product.
- Do not adjust the control of the product in an environment that requires your attention (Operating machinery, driving, etc.).
- This appliance contains a battery that is only replaceable by a skilled person.
FCC
NORTH AMERICA
The Wireless Micro must not be co-located or operated in conjunction with any other antenna or transmitter. The device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation
This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- Company Name: RØDE LLC
- Address: 2745 Raymond Ave, Signal Hill CA 90755, USA
- Telephone
- Number: +1 562 364 7400
This equipment complies with FCC radiation exposure limits set forth in an uncontrolled environment.
Changes or modifications not expressly approved by RØDE could void the user’s authority to operate the equipment. This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
SOUTH KOREA
- ID: R-R-R72-0573T
- Company Name: RØDE Microphones
- Model: Wireless Micro – Transmitter
- Country of Origin: Thailand
- ID: R-R-R72-0573R
- Company Name: RØDE Microphones
- Model: Wireless Micro – Receiver
- Country of Origin: Thailand
- ID: R-R-R72-0573C
- Company Name: RØDE Microphones
- Model: Wireless Micro Charge Case
- Country of Origin: Thailand
Use of the Made for Apple and Works with Apple badges means that an accessory has been designed to connect specifically to the Apple product(s) identified in the Made for Apple badge and to work specifically with the technology identified in the Works with Apple badge and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Please note that the use of this accessory with an Apple product may affect wireless performance. Apple, iPad, iPad Air, iPad Pro, iPhone, and Lightning are trademarks of Apple Inc., registered in the U.S. and other countries. The trademark “iPhone” is used in Japan with a license from Aiphone K.K.
SCAN FOR MORE INFO
View the user guide to learn more
To prevent possible hearing damage, do not listen at high volume levels for long periods.
- RØDE Microphones:
- 107 Carnarvon St, Silverwater NSW 2128, Australia
- Authorised UK Representative:
- RØDE UK, Unit A, 23-25 Sunbeam Rd, London NW10 6JP, United Kingdom
- Authorised EU Representative:
- RØDE EU, Neukirchner Str. 18, 65510 Hünstetten, Germany
MORE INFO
Documents / Resources
 |
R DE WIRELESS GO ii Microphone [pdf] User Guide WIRELESS GO ii Microphone, WIRELESS, GO ii Microphone, Microphone |
