PLT VAPR25 Color Watt Selectable LED UFO High Bay
WARNING
- Installation, service, and maintenance of luminaries should be performed by a qualified licensed electrician.
- Specifications and dimensions are subject to change without notice.
CAUTION
- Do not make or alter any holes in the wiring enclosure or electrical components during installation.
- Verify that the supply voltage is correct by comparing it with the label information on the luminaire.
- All wiring connections should be capped with UL-approved wire connectors.
- The green ground screw is provided in the proper locations. Do not relocate it.
- Minimum 90° C supply conductors.
NOTICE
- Suitable for wet locations.
- Account for all small parts and destroy the packing material, as these may be hazardous to children
Installation Instructions
Hook or Chain Mount
- Screw the eyebolt into the fixture using the provided washer and tighten it. (Figure 1)
- Hang the fixture on the ceiling hook (Figure 2) or chain (Figure 3), then install the safety cable.
- After installation, connect the fixture wire to the main power supply according to local wiring codes.
Wiring Diagram
CCT & Wattage Adjustment
The beam angle can be adjusted by turning the lens left or right. If the lens is hard to turn, loosen the screw in the middle of the lens. Once you have selected your desired beam angle, retighten the screw.
WARNING
- Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
- To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.
- Proper grounding is required to ensure safety.
- Power must be turned off at the breaker before installation or maintenance.
- This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.
- To prevent wiring damage or abrasion, do not expose wiring to the edges of sheet metal or other sharp objects.
- Do not install damaged product. Inspect the luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
- These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.
972-535-0926 I pltsolutions.com Iver 041125
Documents / Resources
 |
PLT VAPR25 Color Watt Selectable LED UFO High Bay [pdf] Installation Guide 7054, VAPR25, VAPR25 Color Watt Selectable LED UFO High Bay, VAPR25, Color Watt Selectable LED UFO High Bay, Selectable LED UFO High Bay, LED UFO High Bay, High Bay |