OXON AG 3A0800V17 Building and Programming your own Electronics User Guide
01 – PLAY & EXPLORE
02 – CONNECT YOUR CARD
03 – START YOUR JOURNEY
Make a gift instead of throwing away
This product contains valuable raw materials.
If you no longer use it, it’s better to give it to someone as a gift. You can also return the Oxocard to us and we will make it available free of charge to other young people.
Warranty and liability
The electronic parts are guaranteed for two years as long as they have been used reasonably and have not been damaged.
We disclaim all liability for any damage (personal injury or material damage) caused directly or indirectly by our product. The place of jurisdiction is Bern (Switzerland).
Version 1.1 – 4.9.2024
Declaration of conformity
The product bears the following CE marking and complies with the WEEE directive
The WEEE symbol on the product or its packaging indicates that this product should not be disposed of with other waste. It is your responsibility to dispose of your waste by taking it to an appropriate recycling centre for electrical and electronic waste. For more information on recycling points for your waste, please contact your local authority.
Improper disposal of the product by the user may result in a fine.
This product contains Open Source software.
The license agreement and other information is available at: www.oxocard.ch
By using this product, you accept the terms of this license.
OXON AG – Waldeggstrasse 47 – CH-3097 Liebefeld – Switzerland – info@oxocard.ch
FCC Caution:
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
– This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
– This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.
– The device complies with FCC RF exposure guidelines when the device used at 0mm from your Extremity.
– Non-compliance with the above restrictions may result in violations of RF exposure guidelines.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
OXON AG – Waldeggstrasse 47 – CH-3097 Liebefeld Switzerland – info@oxocard.ch
Documents / Resources
 |
OXON AG 3A0800V17 Building and Programming your own Electronics [pdf] User Guide 3A0800V17 Building and Programming your own Electronics, 3A0800V17, Building and Programming your own Electronics, Programming your own Electronics, your own Electronics, Electronics |