osmio WATER TECHNOLOGY Dental & Lab Direct Flow Reverse Osmosis System Instruction Manual
The Osmio HT+ Reverse Osmosis System is designed to meet the needs of your Dental Practice or Laboratory. Osmio HT+ primary uses are: · Use in autoclave
- Use in DUWL
- Rinsing of instruments during manual cleaning
- Holding of instruments prior to decontamination
- Use in rise cycle of washer disinfectors
Installation Precautions
- This, and any other pressurised system connected to the water mains, or pumped from a tank or gravity fed, should be protected as appropriate from leaks. It is necessary to ensure that the property where this system will be installed has controlled pressure regulation using a Pressure Reducing Valve to ensure the maximum pressure cannot go above the specified parameters. You are also advised to use a leak detector, such that if any leak is detected, the supply to the system will shut off and not cause damage due to water leaking to the property. This is especially important as water [pressure can rise on the evenings and weekends to over double what you measure in the daytime.
- Please use clean vinyl gloves when handling the filters and touching them. This is avoid any bacterial contamination from your hands to the filters which can then multiply and cause a bad smell in the system.
1. Introduction
The Osmio HT+ Dental & Lab Direct Flow Reverse Osmosis System has been designed and This is especially important as water [pressure can rise on the evenings and weekends to over double what you measure in the daytime.
– Huge saving in the amount of water going to drain
– Overall less costs in bills and improved sanitary condition of the system – all leading to a much more reliable and efficient operation.
2. Product Features
3. Technical Specifications
4. Feed Water Specifications
5. Osmio HT+ Filters
6. Connection Schematic
There are 3 Connections that have to be made, and they are made using simple push fittings:
How to Use Quick Connect Fittings
7. Planning the Installation
8. Installation Step 1: Feed Water Connection
9. Installation Step 2: Drain Saddle Connection
10. Installation Step 3: Installing the Tap
11. Installation Step 4: Membrane & Filters Installation
Before handling the Reverse Osmosis Membrane, it is important that you wear sanitary gloves. This is because if will immediately put bacteria which will start a new family inside your membrane housing and eventually foul your membrane. When bacteria gets into the TDS will increase.
7) Install Pre Filters
12. System Start Up and Operation
13. Digital Controller
Symbol Key
Wiring Key
Digital Controller Specification
14. Filter Changes & Sanitisation Process
Service Log Table
After Sales
Documents / Resources
 |
osmio WATER TECHNOLOGY Dental & Lab Direct Flow Reverse Osmosis System [pdf] Instruction Manual Dental Lab Direct Flow Reverse Osmosis System, Flow Reverse Osmosis System, Dental Lab Direct Osmosis System, Flow Reverse Osmosis, Reverse Osmosis, Osmosis |
