Orbit Dual-outlet digital timer
PROGRAMMING FOR THE
DIGITAL OUTLET OF THE TIMER
Installing the batteries
- Remove the tray on the back of the timer by sliding it out.
- Insert two AA (1.5V) alkaline batteries (not included) and replace the tray.
- Replace batteries when low battery icon appears.
Installation - Attach timer to an outdoor hose faucet and turn on after programming.
Programming the Timer - Rotate the dial to positions indicated or setup.
- Press station button to switch between station 1 and 2 for all programming.
SET CLOCK - Press the + button to advance clock time (hold button for quick advance).
- Press the – button to reverse clock time (hold button for quick reverse).
START TIME - Press the + button to advance start time (hold button for quick advance).
- Press the – button to reverse start time (hold button for quick reverse).
HOW LONG
Set watering duration from 1 to 240 minutes using the + and – buttons.
HOW OFTEN
Set watering frequency as every 6 hrs, 12 hrs, or from 1 to 7 days using the + and – buttons. 1 is every day, 2 is every other day etc. up to 7 days.
AUTO
Timer waters according to programmed time, station, duration, and frequency.
Rain Delay - When in AUTO, press + button for 24 hrs,
48 hrs, or 72 hrs. - Screen will flash between clock and hours remaining before programmed cycle resumes.
- To remove rain delay, turn dial to OFF and then back to AUTO.
Manual/hand watering
To water without interrupting the set cycle, press [MANUAL] button and then use + and – buttons to set from 1 to 240 minutes.
- To remove manual watering (turn off), turn dial to OFF.
- To resume programmed cycle turn the dial back to AUTO.
Troubleshooting
Water does not come on at desired time.
Check if:
- Clock is set to correct time including AM and PM.
- Start time is set to desired time including AM and PM.
- Rain Delay is on.
Timer does not water.
Check if: - The timer is set to AUTO.
- The Hose faucet is on.
- Batteries are low.
- Clock is set to correct time including AM and PM.
- Rain Delay is on.
The water won’t turn off.
Check if: - The watering duration is set to desired time.
- Start times begin after previous the watering cycle has run through all stations and set durations.
When expecting freezing temperatures, timers should be removed from the hose bib to avoid potential freeze damage .
2011 Orbit Irrigation Products, Inc. All rights reserved. All trade names are registered trademarks of the respective manufacturers listed.
CUSTOMER SERVICE
1-800-488-6156
www.orbitonline.com
